Hi ISE v3.01 is installed at ESXI with VM of 20GB ram, 4vcpu, and 300GB disk. After install and run, we can see Application is not running. and then tried several test, but it still cannot run. Please see the below info, Any suggestion? Thanksadmin/a...
HiI have an issue on interface bandwidth traffic monitor on cisco nexus 9000 from PRTG , live traffic looks unstable , there is spikes and drop on traffic , is there any suggestion please ? device namecisco Nexus9000 C9396PX Chassisversion SoftwareBI...
Hi, I currently have 28 Cisco SG350X-48p switches. These switches have different Vlans for our customers. We currently have a printer which is connected via the public ip. We would like to instead allow our customers to access this printer via our ...
Hello all,I’ve recently been working on a switch using fiber cable. Is there a command to make the switch send pulses of light down a specific port for troubleshooting/identify purposes, I don’t know which ports go where inside the building and I’m t...
Hi guys,today I was tryng to do a lab with a WLC-3504 and VLAN using an external DHCP.The Issues is that only the pool made inside the WLC are working, when I swap the primary dhcp server with the external one it stop to works and the Clients are not...
HiAs the title says, what exactly do p12 & po mean?Also, what is unterminated and unstructured?Thanks
Can anyone suggest any steps to backup the data if data gets lost due to network failure???
Dear all, I have a 350 48 P switch. I would like to configure my internet direct to the switch. I have a static addr from the ISP which can be configured on the switch as a WAN. any suggested configuration for this?
We have a cisco ASR1009-X, here we have configured bridge-domain interface using 2x10Gbps interface. But the new virtual interface bdi1 is showing low bandwidth of 1Gbps only.Query:- Even if 10G link is bundled in bridge-domain interface, if the traf...
I just reset my Catalyst 9200L by this command.switch# factory reset allthen after I got this warning message.switch: bootwarning: Bootable URL's in BOOT variable not found or exhausted. please check the ROMMON configuration or BOOT comma...
Telnet server is not enable in C1000-24P-4G-L switch, I am not able to access the switch over telnet. my switch config as belowBuilding configuration...Current configuration : 4641 bytes!! Last configuration change at 14:06:55 UTC Sat Sep 16 2023!ver...
Have to Cisco ISE devices and we used to be able to log in to both the GUI and SSH, but now we can't log into to the GUI, but can log in with SSH. When trying to log in to the GUI, it says password expired, tried with a dummy account that was not con...
Hi all,Can anyone please explain how to identifying and resolving STP loops or broadcast storms, currently we are analyzing the spanning tree topology, blocking/unblocking ports, and preventing future loops. But getting exact solution will help us fi...
Currently, reinstallation of pi is necessary. However, since the equipment was installed a long time ago, it is difficult to check the license purchase history. So, is it possible to access the pi's root shell and download the registered license?
Hi everyoneI am helping with a network setup and am currently stumped with this issue. I'd be grateful if anybody could shed some light on the situation. The issue is as follows :I'm changing Comcast modems at the place, and the setup is as follows -...
