Hey all, I’m a total noob when it comes to networks and switch configuration. The problem I’m running into is that my company doesn’t have local IT to come and get our internet set up, nor does the ISP seem like they can have a tech come out to assis...
Forum Posts
Forum,I am in the process of bringing a few 3850 switches into Netflow.I have configured the flow record, the flow exporter, and the flow monitor.On one specific switch, i have it configured to use vlan 1 as the source since it does not have a loopba...
cisco config-key not showing in configuration after apply below : key config-key password-encrypt password encryption aes encrypted key is not showing any whare in the configuration please support.
Resolved! HA on Cisco Prime 3.9
Hello, I'm trying to rebuild my HA between both Prime node, but the field to register the Secondary server is not available Do I miss something ? Thank you,
To confirm the client's accurate wireless qualityI would like to know the interval at which PI collects roaming records of clients. What is the default value of this interval and can I change it? If you can change it, can you tell what the minimum an...
Resolved! ASDM not working in WINDOWS 11
Hi all, Hope this will help youI have received new Laptop from my organization and its win11.Faced challenge in Running ASDM. After installing ASDM and JAVA ASDM Application wont openTried installing older version of JAVA still same.But finally it'...
Hi to all,i wonder if there is a way with CPI 3.9 to send an email when a specific condition is met , and that condition is when a switch interface with specific description goes to down state.Is that possible?Thanks to all !Ditter
Hi there,I'm looking for a list of default thresholds (fan speed, temperature, power supply, power sensor, etc) for Cisco switches and routers. I've searched the internet for this information, but the results mostly show me how to use the CLI to get ...
Hello team:Let us suppose that I add a new policy map and apply it as a service policy to an interface. I am worried about the policies I had before adding the new policy.¿Will the router preserve the IDs of the other policy maps and service policies...
Resolved! ISE application cannot runing
Hi ISE v3.01 is installed at ESXI with VM of 20GB ram, 4vcpu, and 300GB disk. After install and run, we can see Application is not running. and then tried several test, but it still cannot run. Please see the below info, Any suggestion? Thanksadmin/a...
HiI have an issue on interface bandwidth traffic monitor on cisco nexus 9000 from PRTG , live traffic looks unstable , there is spikes and drop on traffic , is there any suggestion please ? device namecisco Nexus9000 C9396PX Chassisversion SoftwareBI...
Hi, I currently have 28 Cisco SG350X-48p switches. These switches have different Vlans for our customers. We currently have a printer which is connected via the public ip. We would like to instead allow our customers to access this printer via our ...
Hello all,I’ve recently been working on a switch using fiber cable. Is there a command to make the switch send pulses of light down a specific port for troubleshooting/identify purposes, I don’t know which ports go where inside the building and I’m t...
Hi guys,today I was tryng to do a lab with a WLC-3504 and VLAN using an external DHCP.The Issues is that only the pool made inside the WLC are working, when I swap the primary dhcp server with the external one it stop to works and the Clients are not...
HiAs the title says, what exactly do p12 & po mean?Also, what is unterminated and unstructured?Thanks
