Network Management

High Utilization event generated for Nexus 7010 shows in LMS 4.0.1. Please share your input why its generated. We have checked up Nexus, it showed not utilization.

Hello,Cisco NAM provides a good indication of deciding on a performance issue pointing to the Network time of an application, and Server Time of an Application. How does NAM measure this time,  we think it is related with timestamping the TCP Packets...

Hi,i was wondering if there is any way to configure the topology diagram to auto refresh.every time i need to update the diagram i have to close the application and open it again OR i have to do "Perform Data Collection" and press "refresh map".For E...

Hi All,I'm using cisco LMS 4.0, I've discovered the device and next plan is to collect the device configuration.I would like to know,  How I can collect the configuration for single device.What configuration changes required on my LMS & Cisco device....

I am receiving this error msg:%SNMP-3-INPUT_QFULL_ERR: Packet dropped due to input queue fullHow do I clear the snmp stats?What can I do to alleviate this condition?Should I make the snmp input q larger? Can I make it larger?

Hican any one please point me in the right direction to identify the OID to show the “total MAC Addresses In Use” on a 6509This is the value we can see from a show mac-address counters, and I want our Solarwinds system to poll for itMany thanks

Hi,is resetting the databses in LMS 4 the same way as in LMS 3.x ?regards

Hello,I need a help:I installed the Cisco LMS 4.0.1 (test mode), and monitoring services of the switches (data collection and information system) are working.But when I need to apply some configuration via CiscoView settings are not applied.The follo...

Wir haben ein Problem mit unserem RPS 675 und wollen die SignaleRPS_PRES (RPS present)RPS_CTRL 1RPS_CTRL 0PWR_GOOD (power is good)überprüfen.Kann mir bitte jemand sagen welche Signalspannungen (Art der Spannung, Größe der Spannung) bei den jeweiligen...