Network Management

Hi,I have a router configured with ip sla icmp echo to track some ip addresses in order to make some routing decisions.However, although I can ping the IP addresses just fine from the router with the correct source interface, their corresponding ip s...

I have used the GUI to change the location of the /devfiles directory to the /opt directory because I have run out of inodes on the /var directory.  I'm wondering if the old directories under /var will be removed once the GUI completes the change?  W...

I am running CiscoWorks on a Widows 2003 Enterprise server, my RME version is 4.3.0. The issue I just discovered that when I try running a Syslog report out of RME the history will only go back as far as the last server reboot. For instance, the serv...

Hi All, we are running LMS 3.2 with HUM 1.2 in awindows environment.  Currently we have a group of access switches 6509's that loose connectivity for a minute or two and then connnectivity is restored.  DFM picks up on theconnectivity loss and create...

CWLMS-3.2-1.5KMRK9 LMS 3.2CATOS devices not able to add in Cisco Works Giving Errorsplease explain whether CAT OS devices and IOS devices both can be added in LMS 3.2

Hello folksI have problem with portlet in LMS 4.0 "Critical message windows". In the Portlet it says only "Loading" and then nothing happens moreDoes anyone know what I can do? A small checklist where I can start to look for errors ...?Have a nice we...

Hi all,I'm using LMS 3.1 with Campus manager 5.1 and install on solaris platform. When i click on topology services in campus manager, i have received a message as belowPlease help me resolve this errorTks,HTTP Status 500 - type Exception reportmessa...

Hi,   I've a requirement to hash a string, within TCL but I cant figure out whether/how to do it.   Is doing this possible in IOS?  Chris

Hello,HUM was configured earlier to show all graphical statistics however suddenly there are no graphs to show - "No data is available". And it asks to configure pollers even though the previously configured pollers are still active. Attached is the ...

We have an ASA 5510 version 8.2(1).  Can anyone recommend a good network performance monitoring tool?  We have frequent spikes in our bandwidth and need a tool where I can monitor the outside traffic and see what is going on.Thanks!

Hi,We use ciscoworks to do a mass change of our passwords periodically.I want to run a compliance check to unsure then enable password has been changed.So i create a template to check for the existance of something like+ enable secret p4ss0wrdHowever...

I am curious what the best monitors are to monitor on my routers and switches.   Bandwidth, CPU, Backplane, etc....

Is the syslog as an EEM event supported in Nexus I am trying to run an EEM applet based on a syslog but unable to. What i want is to shutdown a particular module when a power supply on the 7K is switched off .. possible?Ambi