Network Management

Hi,From the various posts around here, I read that, in Config Mgmt, LMS connects through Telnet or SSH to devices, then uses TFTP to send configs.In my network, I run SSH on my devices. Device Credentials Verification Job is successful for sw1 and sw...

HiI am carrying out a network audit for a customer using netformx network discovery for the physical audit but the customer wants a network health check including a report on routing, throughput,traffic analysis and voip readiness. Is there a guide o...

I've configured many eem applets on my router, each applet has a lot of CLI actions. I'm afraid when events occur almost at the same time, their actions can be conflicted with each other.Thanks

Hi,Why does the Failed devices count increases after each unsuccessful archive sync? Is it a display issue?

All,Have spent the last couple of days playing around with CSM4.1 in advance of formal testing and deployment.To set the scene we already use LMS (currently LMS3.01 although looking to upgrade) and familiar with the functionality of RME to deal with ...

Problem: To find members of a port-channel on a Nexus 7K running NX-OS 4.2(3)Background notes: http://bit.ly/a9VHHEFrom my reading of the CISCO-LAG-MIB, the clagAggPortListPorts on a port-channel provides a list of interfaces in that port channel:Thi...

I am attempting to configure a discovery filter to exclude my Access Points. The filter looks correct and I finish the configuration. When I run the discovery it stills discovers the Access Points! How can I get the filter to work properly?I have att...

Setup my SNMP with the following......*************************************************snmp-server view readview internet includedsnmp-server view writeview internet includedsnmp-server view readview internet includedsnmp-server group readonly v3 pri...

Hello Experts,I have installed Cisco Security Manger with  RME 4.2 and Comman Services 3.2. RME database was consuming extra ordinary space in C: Drive, which make C Drive full. so the solution i went is:I have reinitialize the RME database successfu...

logrot.pl does not check diskspace before doing a copy process of syslog_info; if there is not enough space, the copy process fails and the content of syslog_log is lost;I know, that the error handling of such a script cannot take respect on each and...