Network Management

We have LMS2.6 and CiscoWorks has been put into a virtual environment.We hare seein a high number of I/O write to the disk and the server is sluggish.Are there some things to look for that could be causing the high number of I/O writes like this?It s...

Hi all!1.     My server have problem with service. In RME module, I see “JRM service could be down, Check whether JRM services are running”. But I go on Common Services > Sercurity > Admin > Progess. I don’t see any services. I don’t know how to star...

Dear Sir,I am new in LMS , would you please send me some documents that i can follow it to control the LMS .thanks,

Hello All,We have a strange problem with LMS 3.2 regarding Inventory Collection.This problem started immediatelly after the LMS installation/upgrade (LMS 3.2 was installed on a new server, and LMS 2.6 database migrated to it).All Jobs finish as faile...

Can we retrieve the pre-shared keys from the configuration archive of ASA from Cisworks LMS 2.6 or higher version ? If so what the steps we need to  follow the same. Please help me on this. Thanks in advance.

Has anyone notice this. All device show's up if you run an inventory report, but when you try to creat a new show job only a handfull of device shows up.Is there any settings I'm missing for all deivces to show up under netshow as well?

What is the best practice for running TCL scripts in IOS? should they be run through EEM (using the eve man run xx.tcl) or directly? EEM allows you to run it with low priority which is a big benefit for scripts that can put a load on the CPU but bugs...

Hi Team,I have a issue with LMS 4.0, I try upgrade IOS for Cat37XX and Cat 35XX and this job Fail.I make a get IOS Repository from this device and this is succesfullI make software dsitribution for Router 7200 and this succefull.I make a Device Troub...

Hi all,equal to thread https://supportforums.cisco.com/thread/2058453?tstart=0 I discoveredproblems with dynamic updates of Device Selectors "All Devices".With scheduling daily discrepancy reports for Error-Disabled Port newly added devices in DCR an...

HelloWhat is the OID of the noise margin for the cisco 878?I have found in the MIB of router the parameter hdsl2ShdslEndpointCurrSnrMgn but the snmpwalk query does not match the show controller dsl 0!Any ideas?PD:# show controllers dsl 0Transmit Powe...

Hi!I'm fairly new to CiscoWorks productlines and trying to learn LAN Management Solution (LMS).Is there any way to virtualize network using LMS and do we have any SDK/APIs available to extend LMS functionality?Pls help!!!Regards,Rish

I have Cisco Network Assistant 5.5 installed and have used it in the past. I came to login today and when i select the community to connect to i get prompted for my username and password. I caanot for the life of me remember what credentials i used t...