Network Management

Dear Friends,I recently purchased some Sunfire X4140 X64 servers believing that I will be able to run my LMS3.2 on the servers.I intended to install Solaris 10 and then LMS3.2 on top.However when I try to install the LMS I get the following message:I...

Hi,I'm having trouble getting ddns to work on a vrf'ed interface. Here's my config:ip vrf provisioningrd 1:10!ip host-list dns-listhost vrf provisioning 1.2.3.4!ip ddns update method my_ddnsDDNS both!interface Vlan2ip vrf forwarding provisioningip dd...

Hello,I have two ntp masters that receive their clock from the internet. Both seem to have lost their sync, as can be seen from the following output.Sw-MK-C6509-R-IS-MHX-A1#sh ntp associations detail 127.127.7.1 configured, our_master, sane, valid, s...

Hello,I changed the transport protocol for images from tftp to scp only. In Common Services, Server Admin I have defined a scp user and password.The ip scp server is enabled on the network components.Now scp works well from the command line of the sw...

Hi Netpro community! I am very pleased to announce the general availability of Cisco Network Assistant version 5.6.While we wish CNA was available sooner, we know there is a lot of pent up demand for device support for the 2960-S, 3750-X, and many ne...

Hello,Does anyone know of a way to test to see if notifications (e-mail, sms, etc) are working in LMS 4.0 without actually taking a device off-line or generating the event that causes the notification, etc?Thanks.  All replies rated!

Hello,This very new model "WS-C3750X-48T-L" v12.2(55) is mapped wrong to bulletin# EOL7309, that is actual about a "3750 Integrated Wireless LAN Controller" in EoX HW reports. Gues the error is located in the EoX database represented by the xml-File...

Hello,the customer would like to use SNMP RW access for configuration of ping on Cisco devices. He wants to use ping with the following parameters: destination address, length, number of packets and with DF bit set (it is very important for our custo...

Hi,I have installed CUOM 2.3 with Service Monitor in the same server.I use  Data Source Credentials to configure Service Monitor. when I check the last contact Status in ( CUSM -> Configuration -> Data Source Credentials) I found that the result is S...

Hello All;I have pb with deamon lms3.2when i try to start the service with net start the following message appear:CiscoWorks Deamon Manager could not be startedthe service did not report an error.Ciscoworks run on windows server 2008 Standard SP1 and...