Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

 
Labels

Forum Posts

Hi All,I have two devices configured in CiscoWorks long back, recently I have changed the devices names and the same I updated in device identify.Now I am able to see the device in device center but not able to see config view, I am getting message "...

Hello,I have a Catalyst 3560 configured to send syslog messages to a syslog server.  This switch has a host plugged into one of its edge ports which resets its link state every 20 minutes (due to an intentionally configured 20-minute restart interval...

Hello all,I've been working on installing a fresh copy of CiscoWorks in our lab at work, I've done this 3 times and everytime it worked, however, this time I'm scratching my head and would appreciate some help/advice please.This is a list of the soft...

Hi all,I have connected  2 routers from each aux port to the other's console port for remote access in case of router failure.Apparently, this generates a few odd behaviours:- Sometimes if one of the routers reloads, it goes directly to ROMMON. If i ...

I would like to be notified through a log message if the router is rebooted (deliberately or otherwise) and either drops into rommon mode or is forced into rommon mode with a ctrl+break sequence.  When I manually create this scenario I don't get any ...

I am setting up our LMS server and when i run device discovery in Common Services it discovers 132 Devices none of which are IP phones.  We currenlty have around 189 switches which all have SNMP and CDP enabled. Any ideas anyone?Cheers

     We have installed Ciscoworks LMS 3.2 on Windows Server 2003 Enterprise edition. We are trying to add 6500 Switch which is in vss mode, CDA job was successful but when we are accessing the switch from cisco view it is showing only one chassis We ...