Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

Hi,I recently upgraded a test router from Adv Sec, Version 12.4(6)T11 to a newer revision in the same track Adv Sec, Version 12.4(15)T13 and completely lost EEM!On the older 12.4(6) version I had a basic test EEM applet but following the upgrade the ...

Hello community,I'm devolopping an SNMP application to monitor my Cisco energywise device.I'm using CISCO-ENERGYWISE-MIB to query the switch's database.I'm able to get and set througth my query all the information I need, But I can't create an Event ...

gimp by Level 1
  • 1326 Views
  • 9 replies
  • 0 Helpful votes

Resolved! Network Port Flap

We are having an issue of network interface flaps which is causing a port flap in our network. Our goal is to have a tcl script that will be able to run whenever we have 10 flaps within 10 secs, the script should be able to shutdown the port that is ...

nycha by Level 1
  • 5556 Views
  • 4 replies
  • 0 Helpful votes

Hi,After configuring AAA authentication on Ciscoworks 2.6,  I can log on Ciscoworks but with no privileges.I can view any related ciscoworks shared profiles on Cisco ACS 4.0.1.After verifying on the web (http://www.conft.com/en/US/prod/collateral/net...

enaforhmd by Level 1
  • 1242 Views
  • 2 replies
  • 0 Helpful votes

Hi,I have the following queries regarding CWM 16.0.Need to check on what all alerts are available in CWM 16.0 and where to find these alerts?How to integrate the CWM with TACACS ?How to SCHEDULE the configuration back up to be taken for all nodes/MGX...

How can we pull Utilization graphs for DS3 as well as PVC's wherein the threshhold for DS3 would be set as 50 % & no threshhold required for PVC. Need latency graphs, MOS delay graphs ?