Network Management

Howdy y'all,We monitor most of our Cisco network devices with SNMP using devmon/xymon and cacti. We do this across a dedicated network management LAN. There are a few devices, primarily FWSM (firewall service modules) and ACE's that do not have netwo...

Hello,I have recently stared monitoring my cisco switches abd routers for memory and CPU utilization. Does anyone know what average utilization is too much and where I should be concerned about performance degredation?I see a few of my older switches...

Hi,We have a standalone Service Monitor server, that resides on a separate server from Operations Manager, we have not a multi-server environment, and the communication between the servers is not enabled by a "trust" model addressed by certificates a...

Dear all,I configured SNMP on all the routers located in my network, I checked the configuration properly but it doesn't have problem, All the routers are showing the configurations via this software(Cisco NetIPmanager with license) , like CPU utiliz...

Due to growth of the network, I need to split a single LMS 3.2 server into two seperate machines (master-slave).I've prepared two new (virtualized) window servers. installed a clean LMS 3.2 server1 (RME, CM) server 2 (DFM, IPM and HUM)I've restored t...

Hello,I have NAM-2 module which installed on 6506 switch and I have tried to upgrade the application image from 3.6 to 4.1 but I got the following error:<#upgrade ftp://xxxxx@x.x.x.x/c6svc-nam.4-1-1.bin.gzDownloading the image. This may take several ...

Hello,the customer uses LMS 3.1 on Solaris. He tried to get the detail information about discovery jobs, but the most discovery jobs don't show information about the number of discovered, devices, reachable devices.... I'm sending you the screenshot ...

But when I try to CW says the device is not in ACS and it is the ACS server that we use for all the other devices.Is this even possible.

I work for a network performance team and we were asked to monitor the CPU Utilization for a Cisco 7613. It was thought (by Management) that turing on SNMP would cause the CPU to be over utilized. We usually poll the device via SNMP to gather this in...

/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-qformat:yes; mso-style-parent:""; mso-padding-alt:0cm 5...

Hello,This is my first time to install LMS3.2. I successfully installed the software but I don't know what is the next procedure and I don't know how to add devices. Please, How can I add devices to the LMS.thank you,