Network Management

Hi All,Currently we have an offsite location which houses our ESXi host and 10 guests. We also have a cisco switch at this site. The costs for running this stand at £2.5k per month. I believe this to be a little excessive and wanted to explore the po...

We have FIPS 140-2 requirement for our Nexus 9300 Switches.We use Cisco ISE for AAA with TACACS+ for SSH connections.  When we enforce FIPS on the   Nexus 9300 switches we lose SSH connectivity.Documentation also states in the configuration guide.......

prisma ll and prisma ll xd mibs file needed

Hi,I am unable to access our device a - WS-C3560X - unless i directly plugin to the console.I was able to ssh to this yesterday but now I can't. I already generated a new crypto via crypto key generate rsa even removed and added the ip domain-nameI a...

Can you help me for error below:  Log Buffer (4096 bytes):ed. To disable feature execute 'no vstack' in configuration modeMar  9 09:53:43.597: %SMI-5-CLIENT:  Smart Install Client feature is enabled. It is recommended to disable the Smart Install fea...

Catalyst 2960x-48 port will not accept a SSH connection through Putty.It will accept a serial connection through Putty. When in SSH mode and you try to connect after about 10 seconds you get a connection refused error box. Thank you for the help.

We are using snmpv2 before and when I do an snmpwalk(3rd party software) I get a lot of those OIDs. Now we are using snmpv3 and I notice that there are missing OIDs and I tried query it on the switch there is no result.Thank you in advance I am stuck...

I have the following script, I keep getting the message " %HA_EM-6-FMPD_EEM_CONFIG: check_vlan_traffic: "end" action found outside of conditional block"but I cant find any offending "end" statements. I am trying to understand what I am conceptually m...

Dear Community, Could I request help to write a TCL Script to ping multiple VRFs each with Multiple IP addresses of their own.Scripts required for IOS-XE and Nexus.  !!!VRF Listaaa_VRF1bbb_VRF1ccc_VRF1!!! IP address list for each VRF set!!! aaa_VRF11...

Hi,is there a way that EEM script issues some commands and a way to read all its content and on some specific output results do some action.For example  =================================================================TEST#sh ip bgp nei 12.12.12.1 re...