Network Management

Hello,I have a Windows LMS2.6 Mgmt station with CSS 3.0.6 and RME 4.0.5I wanted to upgrade to RME 4.0.6.and prior to this, I wanted to backup my data.Nevertheless, I was unable to do this backup.Either with the GUI through Server>Admin>BAckup,  then ...

Can I filter out of sync report in RME?? For example when the router has the different ntp clock-period in the running config and the startupconfig - the out of sync is generated for this device. So I have to a lot of out of sync devices and I have t...

I would need to know if CiscoWorks LMS 3.1 can perform the following tasks:At least once a week connect all our machines a perform a couple of show command. The output of this show should be captured and the results should be sent by email or to HPOV...

Our helpdesk folks use Cisco view to enable/disable ports.  Yesterday one of our switches lost power and the running config was not saved.  Is there I can force Cisco View to save the config so this doesn't happen?If not, does anyone know of a work a...

    I recently added 15 switches to my CiscoWorks install via the DCR.  I waited a bit and none of them were discovered. I tried to kick start a job in inventory in the RME but they wouldn't leave the running state. I poked around the theads here and...

HiI'd like to know what can cause this alarm? as when i check on the switch, i found that the vlan is administratively shut down. I'd like to know on how can i fix this in order not to happen in future. Your feedback will be hihgly appreciated.mdz-te...

I have a 3:de party application that I would like to retrieve inventroy data from the LMS via the commandline interface. I would like to login it to the LMS server (run on Windows 2003 server) via the ssh server already installed on LMS (the SSH-2.0-...

Have a job that simply runs "write memory". It recently started failing on a couple of rtrs:Results for Device rtr1Device DeployedPre Device Execution Message:Post Device Execution Message:Update Startup Not AttemptedResults of Deploy:Message: Comman...

win 2003 r2 serverLMS 3.2RME 4.3.1When a netconfig job (and SWIM job for that matter) executes, I notice the job chages about 9 devices concurrently.  The job is set for parallel changes.  Is there a way to increase the number of concurrent modificat...

Hello All,I have been having series of error on my CiscoWorks Server. It all started when I noticed this error message DCR Server is down or inaccessible. With some information I got on this forum, I changed some services startup to Manual but I am s...

Hello everyone,     I have searched high and low, and yet I am still confused as to how to do this...  Is there a uniform MIB that can be interrogated, regardless of the switching platform? Or are there specific MIB's for each switch family..?