Network Management

I would like to use EEM, preferable an applet to monitor the number of bytes in an output queue on an interface of a catalyst 6500. Has anyone done this that can provide guidence an/or is there a better way to do this.Preferable I'd like to get an a...

Hi There,Attached is the following screenshot of an HTTP 500 error I get when selecting one of my devices in the device centre.-Device is a Cisco 1841 Integrater service router-Am Running LMS 3.1 on Solaris- Ran a pdshow,all services are runningHope ...

Dear all,I added more than 280 VGs to the DCR.All devices are in monitored state.CCMs are 5.1.3 version.Into Service Level View there are only 20-22 Vgs connected with their CCMs.Each CCM has 70-80 VGs registered to.Anybody know why I cannot see all ...

I have a carrier supporting carrier topology.A----DS----CR-----ISP/PE---P----PE-----BAm doing policing by police command to customer "A"on core egress,,towards ISP.I want to verify that is it really police command effective on my 6500 switch.i want t...

Dear Experts, I need a suggestion / guideline for a solution. In Cisco Router we can define Access List, and based on this we can filter packet based on source address or destination address. Is it possible to store this access list source and destin...

when i batch upload IOS via ciscoworks sofware distribution.IOS version from c2960-lanbasek9-mz.122-46.SE.bin to c2960-lanbase-mz.122-50.SE3.bin it always timeout.How can i do.It works well originally

Hi All,I am wondering is there a way of converting or sending syslog messages as an snmp-trap?As an example - could the following be sent to an snmp-trap receiver to be displayed in our monitoring tool:%ASA-1-104001: (Primary) Switching to ACTIVE (ca...

We have LMS3.2I created some reports with my local admin with Accessibility is privateafter integrate with ACS, I can't log in with my local Admin also I can't see the old reports

Hi all - this should be a quick one but my layer 8 head can't get round it.When I want SSH V2 to be my only Transport method of logging onto a router/Switch then SNMP stops working . What have I forgotten ?Please helpThanks

Hello,I have installed LMS 3.0.1 few month back and its working fine with discovered devices,My company ordered QPM 4.0 and i want to configure that,i want to pull the devices from LMS 3.0.1 common services 3.1.1 How can i achieve this any link or an...

I am in the process of purchasing a netflow collector software. I have looked at several packages with similar feature but a wide ranch of pricing models. I have to say that some of the simplest and most well designed interfaces seem to be the chea...