Network Management

After starting the device discovery I got some unreachable devices. These devices have a wrong, invalid IP-Adresse from a previous installation. So I cannot ping the device to find out the MAC address. How can I find out on which port of an already m...

The device is not present in RME, but the RME job collection status shows the job is running.please help if any solution..

Cisco LMS 3.1 In LMS --Devices deleted in Common Services are still refelecting in RME database.Pls let me know the reason why the devices are still seen in RME?How to overcome this issue.

I am looking for a network monitoring tool that will provide me bandwidth analysis (incoming and outgoing traffic), latency, availability and anythign else that could be useful to understand how the network is doing.  I know that there are a lot of c...

When creating a job report from a  User defined group ex 1000 devices. When then making a new device discovery and  its finding ex 2 devices and adding it to the user  defined Group. Do the  scheduled job report understand 2 more devices are found or...

Dear NetPro,I have a new installation for LMS3.1 for windows on Windows 2008, actually during the setup process I got message informing that LMS3.1 is not compatible with windows 2008.Please is there a workaround, Service Pack, or new image to resolv...

I'm using various Cisco routers and switches. Cisco 2811, 1841 routers. Cisco 3560 switches. I'm using net-snmp tools in UNIX.The output below is snipped to show what's important. When I use snmpwalk I see interfaces with errors. When I use the Cisco...

I recently used the fix option under CM discrepancies to fix three issues. When the job completed and showed up in change audit it had a different username associated with it. The user is a valid user on works. Any ideas why?ThanksBill

Running on a Windows 2008 (with SP1) system.  The system was running properly until someone tried to run a script they had been using on the previous LMS 3.1 system.  Now the daemon manager will not start, and the dmgrDBg.log file has the following e...

Hello,the customer has a problem with PoE devices in the Topology View. :-( He doesn't see the 2960 PoE devices with the PoE filter enabled in the topology view:-( He uses LMS 3.1 on Windows.In the NetPro discussion I found that the list of PoE devic...