Buy or Renew
Buy or Renew

Network Management

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Labels

Forum Posts

Start a conversation

ciscoworks lms3.0 not accessible

Hi Clarke Cisco Systems,Im experiencing problems with ciscoworks lms3.0. Im unable to access the portal everyday morning and i have to restart the services inorder to make it functional. we are getting the page can not be displayed error while access...

secureIT by • Level 4
  • 2937 Views
  • 21 replies
  • 0 Helpful votes

Resolved! save non active device config archive.

what's the best way to keep old device config archive? what I am saying by that, we have old device no longer in use and I want remove them from LMS but the same time I can't to keep their archive for rainy days. if I deleted from RME,CM the archive ...

Resolved! Changing browser logout time in LMS 3.1

I am having issues adding devices in CS if I am logged in more than once (such as with the admin account) which occurs if I just close out the browser. I remember editing a file in earlier versions of LMS to shorten the automatic logout value. Can yo...

drizvi by • Level 1
  • 1072 Views
  • 3 replies
  • 0 Helpful votes

Resolved! LMS 3.1 CM Discrepancies

Hi, is there any possibility how to purge all discrepancies which are already fixed? I know there is an Acknowledge option but would like to have an actual status without checking all the retired discrepancies.Thanks for your ideas.

puk by • Level 1
  • 1184 Views
  • 5 replies
  • 0 Helpful votes

Switch management

Hi,I need to configure read-only user to a Cisco 2960 switch. They want to see the config.How can I hide enable password in config from the read-only users. The encrypted password is not enough.

IP SLA Headache

Hi All So, I need to measure rtt levels between two devices and trap when it is too high. Sounds like a job for IP SLA right. I am trying to do this on a 7200 and a 6500. When the threshold goes above 30ms I want to send an SNMP trap with custom text...

Resolved! RME supported device

Hi,I checked for RME supported devices and found that CAT 2960 PoE (WS-C2960-24PC-L)switch is not supported. Is there a way or update that I could install so that RME would recognize this device? I tried running the device update but it could not sol...

Load more