Network Management

I would like to create an RME job to do mass hostname changes so all our network equipment complies with our naming convention. Does anyone had an example of how to create this job using RME or if this can even be done?

Can it be done?Trying to upgrade on my ol' 2501's to 12.3 turned into such a disaster; I had TFTP checksum errors ad nauseum, and many other probs.A forum member told me the TFTP client in IOS (or bootstrap? it can't be in IOS if it's copying the im...

I started a manual backup yesterday afternoon, planning to upgrade the CM and DFM modules. Today, I saw that the backup had been created but nothing in the dbbackup.log file (0 byte in size). I tried to run backup again and got an error message. I ch...

After the upgrade from LMS3.1 to LMS3.2 the syslog file location changed back to the original settings on d:/PROGRA~1/CSCOpx/files/rme/syslogWhen I try to change it back to the settings before the upgrade on E:\CW_Syslog\syslog.log suddenly the messa...

Hi, We are facing problem of Spamming from our networks. Is there any command in cisco which we can execute on our cisco device to control or block ports responsible for spamming or If some other solution with anyone(except third party device or so...

We recently purchased a Cisco 1841 to handle office connectivity to the internet through a T1 Circuit. Ever since the router was installed I have been monitoring S0/0 through SDM and have noticed that it gets maxed out during peak hours due to intern...

Hy.Everytime the ConfigMgmtServer process is started it will be shut down automatically after 10-20 seconds, but EssentialsDM and DCRServer are running normally.Why is this happening and how can I fix this?cheersMarc

I recently deployed 70 switches 3750/3560 which also now requires an IOS upgrade. Can I schedule a reload using Cisco Works. I used Cisco Works to install the new IOS but the did not allow a reload at that time.

we have a new line, the carrier DSU is 100M full, we set the router to auto but it becomes half.it doesn't go up when you change it to half or full.Any suggestions what the cause might be?anything missing?Please advise.Thanks

Hi can any one guide on how we can disable a specific switch port on Catalyst 2960 switches for a specific period of time. NTP is running on the switch.

Running LMS3.1 - RME is showing on device as an alias in the RME Device Status portlet. The list of alias devices however doesn't show any devices. How can this be cleared?

HiI am tring to install LMS 3.2 eval on Windows Server 2003 Enterprise Edition SP 2 and get the error when start lms-3-2-Win-eval.exe:Windows can not access the specified device, path or file. You may not have the appropriate permissions to access th...

HiI am setting up cisco ACS appliance 113 Server (4.0). GROUPS DEFINED ============== Group 1 : admincentral Group 2 : limited admin Group 3 : education Network device groups NDGs Defined ================================== Swi...