Network Management

Hi!How can I filter messages that are sent over email?I am curently recieving a lot of emails regarding VLAN going up/down. LMS consideres this as a critical event.This is warning message:-----------------------------------------ALERT ID ...

Please suggest how to manually collect inventory (Create jobs) for RME 4.2

We have CS3.2 RME4.2how I deploy template with a command that asking for confirmation such as "Clear ntp server all" in CatOS devies

Hi I get the following error when i change the authentication mode to ACS "Not Reachable- ACS Admin credentials may be wrongly configured in "AAA Setup Mode".- IP Filtering may be configured in ACS.See the "Reports and Activity" -> "Administration Au...

Hi, I have an issue with a new LMS install in which DFM attempts to import devices from the DCR and stays in a 10% learning state. I have waited over an hour now and no change.I have already done some research on this site, and verified the name is ...

I configured cisoworks LMS 3.1 to use ACS authentication. "ciscoworks" is the username provided to it for SSH/ Telnetting to the devices. Is there any way to check whether a configuration change made is via the CW GUI or through the CLI of the CW ser...

Hi,I have a very general question about LMS. If my devices are added with IP address and I change a IP address of a device, what effects would be there in CiscoWorks. Does the Ciscoworks automatically detects the change and apply it to the device or ...

hi to all,I am facing a unique problem in ciscoworks, actually what hpnd after clearing ospf route, the core switch turned red with all devices conneced to it though i have no problem in core swich and its working fine but all red link on core didnt ...

All,RME 4.2 Compliance Check does not work when you try checking SNMP strings, passwords, or TACACS key because they're encrypted in the config archive. Is there a way to configure RME to have Compliance Check look at the actual value?Stephanie