Network Management

HiI have successfully installed CiscoWorks Common Services 3.0.2, and CiscoWorks Voice Manager 3.1.0. However, I log in to Cisco Works, and when clicking on CW Voice Manager, it asks for credentials, I try to login using superadmin and the password I...

I'm after some help to understand when I can use a nested policy in QPM 4.1. I want to avoid having to write ACLs multiple times and ai get the impression nested policies may help here. However, the docs are pretty poor so don't tell you when you can...

HiMy data center, HO and Branch office use a lot of Router and Switch. somes device are add my network and some are gone for meintenence . so its a big trouble to manual handle the device . My concern is to deliver the status of devices position at a...

HiI have a problem, there are 10 devices in unreachable state but I can reach them through ping their IP address from ciscoworks server, they have correct permissons (access-list with IP address CWs server, SNMPv2 community string). When I perform da...

We have installed the evaluation version of HUM 1.1, we tried to monitor the interface utilization of some devices, we could not get the report for this, but we are able to get the reports for CPU utlization.Is some thing more needs to be configured?...

Can we get an e-mail alert for a single switch failure or a stack cable failure in a 3750 stack. We have already configred for the e-mail alerts for the switch failure and we are getting the e-mails.How it should be done in LMS 3.1

hey folks,using wireshark to capture some data for my cisco works server...I've noted that there is a huge amount of multicast traffic to 239.255.2.3....has anybody else seen this? is it normal...seems to be almost every other packet.

I'm studying for my ccna, the 2500 router I have will not allow forced ssh input on the vty lines, I know my commands are correct, I'm using a cisco book I got at bootcamp.Can't figure out why it won't let me use ssh only....thanks

I have an IP-SLA requirement.I have created a PPT with the architecture and requirement mentioned.Requesting your help to make this work.

Hi,I recently made a change to all our switches using a netconfig job. The job was successful so I decided to use the Sync On Device from RME to write and sync all the configsThis seems to have worked for the majority of the devices but 56 of them ar...

We would like to use syslog-ng to feed the syslog analyzer without having a collector store. Is there a way to do this?Also, if anyone knows where there is more documentation relating to the syslog collector and analyzer, it would be very helpful to...