Hi everyone,I have a problem with one of my Customer who wanted to renew the Hardware. I build them a Server and a Network which has 6x Cisco SG550X-24MPP Switches. I made 2 V-Lans: 100 for a Client Pool and 200 for Surveillance Pool. On the Switch P...
Forum Posts
Hi Community, Currently I am having issues monitoring BFD's uptime on my routers and based on the uptime to run an X action. Basically I have an applet monitoring BFDs state which if its Up, then triggers an Action and it works fine, however, if BFD...
Hello everyone, I need to replicate the functionality of client VPN (AnyConnect) set up in ASA on MX95. my 1st question is how to view the configuration on ASA and also the set up procedure on MX95. I just need more clarity to be sure I really get it...
Resolved! Two switch 2960s connectivity issue
Hai I have two cisco 2960s switches connected on poe of other vendor switch on different sites. If one 2690s goes UP on same time other goes down vice versa, how i can fix this issue. kindly guide
I'm configuring a cisco switch and wanted to know how to enable dhcp so that the switch is pickup up the dhcp from the dhcp server. Is there a way to do it in the command line?
I have a customer with PI 3.4 installed (ESXi VM). They need to upgrade to a minimum of 3.8 to support some new hardware (C9500-24Y4C-A switches). I have looked at the release notes for versions 3.4 thru 3.10 and can see a sort of path. 3.4 -> 3.5...
Hello,Does anyone know how Cisco Prime discovers the IPs of the clients? I have a lot of wired clients that detect the MAC but not the IP. It seems that only detect the IP of the client with DHCP serer enabled. Thanks
Resolved! SNMP module monitoring for catalyst 9400
Hello, does anybody now which OID to use for a module status monitor. The cisco-stack mib is not available on cat9k.Thanksoliver
Hello everyone,Can you please help me with the appropriate OIDs for a router ASR 9906 version 7.4.1?- Get the numbers of connected users.- Get the number of BGP routes for each of the configured VRFs.- Obtain information about the status of line card...
Hello people, I would like to know if there are any limitations on Prime to configure multiple interfaces in order to monitor different segregated networks that do not comunicate with each other. I couldn't find any documentation on this kind of dep...
Hi all, I got an issue with a Cisco ISR 4331, it has been configured to work as a DNS for some small network with other network devices (Nexus, Catalyst and others), but the name resolution is not working properly. When I use the resolution form the ...
Hello Folks, I am new to Cisco Prime Infrastructure. Version of my setup is 3.9.In our setup we have many router globally which are running in customer locations and added in CPI.I want to see all of them in global map view. When I created new buildi...
Hi. i upgrade C9404 SUP-1 16.12.04 -> 17.3.1 and then i checked. new port ap3/0/1 has been discovered. ap2/0/1 didn't exist in 16.12.04 version. --------------------------------------show int statusPort Name Status Vlan Duplex Speed TypeAp3/0/1 conn...
Hi friendsMy question may seem a little simple!I've configured my asr 1002-x router for web-based authentication (Authentication Proxy).but whenever I type router's IP address in browser, the webui page appears and I don't see the authentication prox...
HaiI have issue on two access Cisco 2960 switches connect to Ruckus icx7150 by TRUNK port. Cisco's 2960 port blinks Amber even if I remove the cable,, while same connect port on Ruckus is down. If I reboot the Cisco's 2960 for some time its working f...
