Network Management

Hi,One of my clients have installed LMS 3.1 and they have one question. An alarm is registered in DFM and then Topology View of Campus Manager show red colour if one device has a critical alarm, yellow colour if alarm is minor, .... Can I change the ...

Hello,we manage a lot of access points with WLSEs. Now I want to get the wireless clients from the WLSE into the LMS Campus Manager.WLSE is SNMP reachable and SSH access works, too.What I have to do else to get the client data from the WLSE?Campus Ma...

Has anyone here changed the management VLAN of the controller? If so, what is the best way to do it?I need to change the management VLAN of my controller. I already have everything in place, everything working but I need to change the VLAN ID of my c...

HyThere is a place in LMS where i can se the job of the back-up? I want to find the job.id

Hi,We need to implement an emergency workaround to protect our environment based on therecently released bugID CSCsy4140.Our objective is to implement a snmp-server view which prevents access to any SNMP OIDsthat are identified in the CISCO-ENERGYWIS...

I have an ASA5510 that I am having trouble syncing the archive. When I look at the difference between the configs, there seems to be no difference. What would cause the archive to not sync? (Startup)SNMP snmp-server community ********(Running)SNMP...

I have multiple servers attached to this switch-A.but not discover by UT not all but some of them. when I run sh mac-address-table on the switch I have found the missing server mac-address, also when I have run sh ip-arp to the mls switch which is th...

Are they any patches or fix for LMS2.6 to support SHHv2?

we have few servers attached to Cisco load balancer. I have tried to find this server information on UT but nothing.actually CiscoWorks seen our load balancer as end devices. is there anyways to track for devices attached to load balancer??? thank in...

Hi All, can anyone provide me with a link or a documentation for how to integrate cisco routers with rsa tokens ?thanks for the help.Jean

I ran a netconfig job to add some AAA lines to some of my devices. It got stuck on a 2811 router. It entered the commands successfully, but the job status never updated properly. I tried canceling the job back on April 7th and it's still sitting i...

Hi, We have LMS 2.6. Today we got one of the blade bad in our 6509 switch but we didn't recieved the alert through LMS.I did checked all the alerts in LMS but couldn;t find it. Error message in the switch logs is *Apr 16 08:37:57.659 DST: %PM_SCP-S...

We are running VSS on two 6509, device is present in DCR but although it is also present in CM 5.0.4 still its not recognized, listed as "ciscoProducts.896" under device type.Also I am not able to see both chassis in ciscoview & there is ? mark on ic...