Network Management

I have just installed LMS3.0 in a customer network. The DFM does not work as the devices imported from DCR is stcuked in the listening stage. My DFM version is 3.0.0 and I have been following the forums thread to resolve the problem but was not succe...

Facing problem with the syslog collector. No message counters are displaying or increasing in the forward of syslog collector. Able to receive the traps sent from all the devices within the KIWI syslog software which i had temparory installed on LMS ...

The behaviours of "storm-control action shutdown" between C2950 and C2960 seems not the same, please note the following:C2950:C2950#show logMar 10 11:22:36.312 C2950: %STORM_CONTROL-2-SHUTDOWN: Storm control shut down FastEthernet0/18Mar 10 11:22:48...

After setting up single sign-on and DCR master-slave I've tried to do application registration between 2 servers both running Common Services 3.2. The idea is to have all application on the same page. My customer would like that, so I try.Where I ent...

Hi,From my Cisco Switch 4507 I am getting huge Traps...hence lots of mail from my NMS. Can anybody give me docs/links or idea what this Traps really are,-1) .1.3.6.1.4.1.9.9.43.1.1.6.1.32) Message: tslineSesType: 5, tcpConnState: 4, loctcpConnElapsed...

Hi, I am trying to configure SPAN session via NAM2 on Cat6500 on two VLANs which is allowed on data port 1 of NAM2 module. When I click save on the SPAN session row, I see the prompt 'Currently, its not possible to know the Save status. You can conti...

hii,we facing problem in RME, we are getting log like Inventory Collection Failure Scheduled by Polling Job 1004.15 Mar 21 2009 12:02:00 1004.15 System Inventory Polling Failure System Inventory Polling Job ????

Hi, Is it possible to capture packets passing through a specific physical Cat65k port via NAM. Or it has to be all ports/all traffic. Thanks.

Hi, I would like to know that there are so many network monitoring 'software' tools out there, why should one go for NAM 'hardware' module. What are the additional benefits. Rgds.

The CiscoWorks LMS3.01 does not display start screen which is login screen.i do not know why it happens. does anybody have a this problem to solve?

Can DFM detect and report if and when a network interface on a switch or router goes does and send en email alert?If not, can it detect if a device goes down and send the associated notification.

We recently installed CiscoWorks. The dervice configurations were archived right after the installation. They have not been archived since then. Both periodic polling and periodic collection are enabled and configured to run daily.What else needs to ...

Hi TeamPLSE LOOK INTO THIS MATTER, wea are not able to archive config for some 4510,WLC and 6509-E...some of devices are showing in the list of RME but when we rae trying to sync archive these devices are in disable mode..plse find the snapshots and ...

MIB CISCO-STACK-MIBName portOperStatus.2.1iso.org.dod.internet.private.enterprises.cisco.workgroup.ciscoStackMIB.portGrp.portTable.portEntry.portOperStatus.2.1OID 1.3.6.1.4.1.9.5.1.4.1.1.6.2.1Type INTEGERUnits Access read-onlyStatus unknownVal...