Network Management

Hi, We had a plan to purchase a switch and a router but can you suggest me some switch and a router which as a following feature For Switch : 1. Chasis comuntator feature level in L3 and L4 2.Speed Commutation higher than 60 Gbps 3.80 ports 10/100 Mb...

I have enabled RADIUS authentication. Now anyone can login to Ciscoworks. How can I limit it to only specfic users? How do I control Roles?

I am having two routers added in the Campus Manager. It shows me a single serial connection between them but i am having two serial links between them.So is it possible for the CM to shows both the links.regards,Pulkit

I finally have LMS setup the way I want and the boys I work with wanted to see the device names rather than just IP. I setup a hosts file on the server and started a discovery. I thought that the names would be replaced but instead it discovered al...

I think I have a final problem with my configuration of netflow...It is difficult to explain my configuration so I put it in an Attachement...It is configured on a router (cisco 2620).If I use a snmp network tool I can see the router... So there is c...

I'm new here :) I'm a network technician/low-voltage electrician and I need to determine which machines are connected to our switch ports. Is there a Cisco tool that will provide this information? The company does not want to pay for SolarWinds :(

I recently had the shocker of installing a new card in my 6509 to find that it went into PwrDeny state. Taking a closer look via "show power" I saw the twin 2500W power supplies listed as actually pumping out less than half that power.Question 1: Sho...

If I'm trying to push an image that is too big for free flash, are there any options in RME to delete the existing image to create the needed space? thanks!

Hello everybody.I have follen in love with EEM ;-)I am looking for simple way (without tcl)to limit the action to take place not more than x times.If you monitor syslog for ios bug occurance that at some point starts generating 1 message a second you...

Joe,I seem to remember there was a page that I could look at the various log file sizes but I don't remember where that was.Also, one of the logs was a tomcat log.Are these usually logs that are only started when you are troubleshooting?If so, where ...

I'm trying to forward based on IP-precedence bitspc--->switch--->c1700----->c3640---->3750The 1700 successfully classifies packets with "ip-precedence critical" (5).Next step is for Cisco 3640 to prioritize forwarding...how can I do this with a 3640...

Hello, I have large network with many high priority customers, in CiscoWorks DFM I configure notification in compliance with our policy. But we also need notification about down customers and uplink interfaces. Can you help me configure this notifica...

some isp limit only one computers can use pppoe dailup by it's mac address,but ppp line do not need arp protocol and mac to transfer data,so,how can they do that? how to find the customers mac address through ppp line?thx very much