Network Management

I just installed 2.6 and when I get try to open the HP I get the message that says the services are still starting. I did a pdshow at the command line and all services are running. The only problem I see is that everytime I try to open CiscoWorks th...

starting with LMS 2.5 the 'unused up' and 'unused down' reports where introduced; that means, UT stores information for all endhost ports in the DB, regardless if they have an endhost connected or not. So my question is if the following is correct fo...

Need some input here. I am working in a network environment in which we have been using a Unix/Linux proprietary software product for network management. Historically, we have used the terminal emulator built into the software with which to load conf...

Hello,after I change the ip address of a device, the ipm source will not be updated. DNS for the device is working well. How can I tell the ipm to update the address of the source?UMartin

Dear Netpro,Does LMS 3.0 have Telecommunications Management Network TMN interface? I'm afraid not, but need confirmation.Kind Regards Boldizsar

Lately I've noticed a number of instances where Cisco devices sent linkDown traps with "locIfReason: up". Is there any known bug for this kind of behavior?For example: A cat6k sent:1184761877 7 Wed Jul 18 08:31:17 2007 rtr1 - Cisco Agent Interface...

Hi,I configured priority queuing on my Cisco 2800 serial interface.Four Queues high ,medium,normal,low were assigned a queue size and mapped with an individual access list.I would like to monitor the packet drop rate at individual Queue using by Nms ...

I had issue with CM UT 4.0.8 which reported duplicate MAC addresses with different timestamps.I upgraded to CM 4.0.9 and reinitialized ANI DB.After ANI discovery and UT data collection, the issue is the same.UT reports duplicate MAC address on ports ...

Hi, is it possible to install the latest release of the UNIX ACS also on the Solaris 9 or 10? In the release notes only Solaris 8 or older is mentioned. Thanks, Peter Filo

Hi,I am planning to migrate a customer network from snmpv1 to snmpv3 with use of authentication and encryption -> authpriv.Does anybody have experience in using snmpv3 and encryption concerning resource problems on network components and network man...

I am having problems with CISCOWorks LMS 2.6. I could access it with IE 6 but not with Internet Explorer 7. It says 'cannnot connect to ANI server: ANIServer5.0.3-Orion. Verify that ANIServer5.0.3-Orion is running and restart campus manager'. It work...

Hi AllI have configured snmp properties from Cat 4003/4006. Changed the public string and configured ip permit list for snmp to the Ciscoworks Servers.I cannot get any syslog messages on the boxes or in the Ciscoworks syslogs.Please help.Thanks

Hi,This is the second time I post for that kind of issue:the baseline template is really powerful for massive change but limited with acl.I mean ACL is really the kind of things which is helpful to modify in mass but as soon as we just add acd line c...

I'm looking for input from the user community on where I might find scripts to perform inventory on Cisco equipment (Rtrs and Switches of various models). I see where I can walk the OIDs below and get cardInformation for routers and was hoping I cou...