Network Management

Hello,The odbc.pl and snmp.pl processes are failing on our CW Windows 2000 server. I tried stopped and restarting the CiscoWorks Daemon processes and rebooting the server - no luck.Any assistance would be greatly appreciated.Thanks,Bob Schlifke

Hi Guys,I am some what new to netflow so any assistance you could give me would be greatly appreciated.I am running a 6509 Sup 720 - 12.2(18)SXF5. I have setup Fluke Networks NetFlow Tracker as my netflow collector and my configuration is as follows...

Hello,I am trying to setup a QoS policy on our routers for better performance of Windows Terminal Server for our remote offices. We have 1841 routers in each remote location connecting into the 2800 series at our main location (spoke and hub). Each...

When I remote into my switches using either telet or SSH some switches require the enable password be entered after my username and password, and others place me right into priv. mode. What line configuration do I need to make to have the enable pas...

Hi folks!!I have a feature product question:Anybodies know which of the following product:LMS2.6CSM suite (CSM+MARS)can give a report about a "Router interface utilization".For example.. this feature is contained on OpenView NNM -> Report Presenter.I...

We have an ACS server with numerous groups and users that work fine.I have one user that is stuck in the ACS database and I cannot delete it.When going to the user database, it is if he has not ever been fully configured. When selecting that user, th...

HiI'm receiving the following error while trying to fetch a config via SSH or TELNET (transport order) *** Device Details for <DEVICE> *** Protocol ==> Unknown / Not Applicable CM0151 PRIMARY RUNNING Config fetch failed for <DEVICE> Cause: Could no...

Hello,Do you know if it is possible to request a cisco 805 router with SNMP in order to get traffic with top Ips or protos consumers? We have bootlenecks and look after a solution for understanding the root cause.Many Thanks for the answer,Alain Ganu...

HiI have install LMS bundel common service 2.2. RME, Fault Manager Cisco View is running well. I can view desh Board from fault Manager. But when I browse CAmpus Manager 3.3 then no respond.I configure Server Configuration > Setup > ANI Server Admin ...

Hello,As you may notice by my conversation title, I'm a complete newbie to Cisco. All I really need to know is how can I determine the IP address for my 2600 series Router? I have no idea how to communicate with it. I'm not familiar with any softwa...

Hi,I am facing a problem with device discovery.It shows the loopback IP address of the devices instead i want to see the management IPs.Can anyone give a solution for this asap.

hi, i have 1 of my routers configured to be access through ssh only. When i update my inventory, there is only telnet field.. I have updated the inventory with the secret password, but i get "failed" under telnet column.. This is causing me following...