Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

IE-3300 Series Switch [% Platform cannot support remote-span mirroring on VLAN with more than one member po

For an IDS Design we would like to configure multiple RSPAN session which is working fine for some other Cisco Products like IE-4010-4S24P, WS-C3750-48TS, IE-3000-8TC…unfortunately we struggling to enable this on our IE-3300-8P2S devices using ie3x00...

Resolved! Cisco 3750 48PS for home use

Hi All,Very new to switch configuration.  Picked up a refurbished 3750-48PS that I want to use in my home network.  Yes, I will have a bunch of ports throughout the house.  Can you point me to a resource on setting this up?  I am fairly familiar with...

SNMPV3 can not work on Cisco 72000

Cisco IOS Software, 7200 Software (C7200-ADVENTERPRISEK9-M), Version 15.2(4)M11, RELEASE SOFTWARE (fc2) hi I'm trying to config and run SNMPv3 for first time I but it doesn't work. now I have an router on my lab and a server with multiple snmp manage...

Cisco RV325 Subnet Table

I have a Cisco RV325 router that I configured on a test network several months ago.  Somehow I changed the default 192.168.1.1 subnet to 10.0.1.1.  My configuration is done and working, and now I want to change the subnet to 192.168.5.1 but have not ...

rdk_cisco1 by Beginner
  • 1150 Views
  • 2 replies
  • 0 Helpful votes

WAP571/TP-link scheduler in repeater mode

We have a WAP571 and set the scheduler between 08:00-17:00 for the workinghours which works fine.Now in another area we connected a TP-Link as a wireless repeater to the WAP571 which also fine exept for the scheduler.Is this normal that the wireless ...

EricM5 by Beginner
  • 1141 Views
  • 0 replies
  • 0 Helpful votes

Resolved! Cisco ASR 9010 iBGP

Hi, I have two ASR9010 Routers. In one of those I have advertised half of my IPs in my BGP configuration and in the other one the other half. I want to connect two routers together using BGP to exchange each ones prefixes. Do you have any idea how to...

aridy by Beginner
  • 1226 Views
  • 1 replies
  • 0 Helpful votes

Cisco Prime upgrade 3.4 to 3.7

Hi, I am trying to upgrade Cisco Prime Infrastructure 3.4 to 3.7 version. PI-Upgrade-31x_32x_33x_34x_to_3.7.0.0.159.tar.gz file is 4.4GB size, but when I try to transfer it to Prime via TFTP - it shows as if the file size is 224MB. After it is comple...

Pakellmute by Beginner
  • 1388 Views
  • 3 replies
  • 0 Helpful votes

Sg 250 10_100-1000 problem

Ihave cisco sw sg250 26 port this sw connected with two uplink one to the sw 2960 and another with sg 250 and the core sw 3650 in 3650  I created vlans and activite vtp version 3 but sg 250 didnot understand vtp......this infrastructure now when i re...

amrashraf1 by Beginner
  • 1341 Views
  • 0 replies
  • 0 Helpful votes