Network Management

Does LMS (Cisco Works) support device management accross WAN sites (connected thru HDLC/FR/ATM) ? If I have a LMS2.6 ( 300 device lic) and i have 2 sites. Each site has 100 devices to manage. Can I deploy LMS at one of those site and manage/monitor t...

Hello there, I'm looking for a mib that can give me the size (number of entries) of the ARP table in a Cat6509. So far I have found how to get the ARP table entries from the atEntry or ipNetToMediaEntry OIDs, but I dont need the individual entries, b...

hellow everyone. how i will do when it happens in CMTS UBR 7246VXR that "voltage critical range!"Voltage readings: +3.5 V measured at +3.27 V :Voltage in Critical range!help me please

HI,Campus Manager keeps reporting BPDU-Guard and BPDU Filter as being disabled on the access ports of all of my 2950s, when in fact is is enabled. I've tried global and port configs on the switches. I've reset those physical discrepancy settings( c...

I am investigating network performance issues on a DMVPN network. There is evidence that packet fragmentation is occurring on traffic traversing DMVPN tunnels indicating that Path MTU Discovery is failing.I've reviewed some of the router configurati...

Would any Cisco experts be able to lend a hand with the following ACL requirements that I need to implement on a Cisco router at work?1. Block all inbound ICMP messages with the exception of Echo Reply (type 0), and Time Exceeded (type 11). ICMP mess...

Hello,Can somebody send me the OID or MIB of the query of the count of the currecntly logged in users. I mean the number of users who use VTY lines.Thanks in advance,ByeFCS

Hello,We have CNR 5.5.6 installed on Windows 2000 server.We would like to survey the status of DNS and DNCP services from an HP openview stations on Unix version 7.5.I have install the CNR mib on HP and we are sure that snmp is running on windows, bu...

HiI have upgraded from LMS 2.5 to 2.5.1. I have alse re-registered all applications with ACS from the AAA mode setup page. This was successful on both ACS Servers.My device list under all LMS modules is however empty. If I run a report to check for D...

I am currently running LMS 2.5 with the latest patches on Win2003. From RME I can collect running/startup configs. However, when I run a second collection I get the following message:CM0060 PRIMARY STARTUP Config fetch SUCCESS for R1, version numbe...

Trying to import image from CCO into RME repository. Credentials and proxy authentication all OK and select image and subsets fine when creating job. After job runs, result fails with below message...-----------------Start images downloading:Image 1 ...

Hi. I've a PIX525 ver5.3 I'm trying to traslate a private address 172.16.0.0 to a public address 200.12.176.62 The first address is a DMZ4 and the second is the traslate to outside. I have thist instruction: NAT (dmz4) 2 172.16.0.0 255.255.248.0 0 0 ...