Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

I have a customer that has Ciscoworks installed. (Current modules installed are RME, Cisco View, Device Fault Manager, Common Services, Campus Manager)Can the customer do config pushes to the VPN and PIX devices using what they have installed or do t...

I have Ciscoworks LMS2.5 on a windows 2k server. I would like all config changes to be emailed once a week. I have snmp enable traps config & logging syslog facility pointing to my Ciscoworks sever.Where does Ciscoworks show these logs/changes and ho...

woods8 by Level 1
  • 1375 Views
  • 4 replies
  • 0 Helpful votes

Hi! I noticed that when backup are being done over the LAN, it's quite a common practce to have a seperate LAN to do these backup of remote servers. I'm not sure how is these being done pratically? Does that mean the servers will need to have 2 NIC c...

dkblee by Level 1
  • 4251 Views
  • 13 replies
  • 0 Helpful votes

Hi,Currently, I have upgraded my LMS to 2.6 and CM to 4.0.7.My user tracking when I ran it, it only produces the following MAC address, port, and the name of the switch (where it is connected). It doesnt have the IP address and the Hostname.I would l...

eugene.uy by Level 1
  • 992 Views
  • 2 replies
  • 0 Helpful votes

I would like to try setting up rmon on our cisco 3560 switches and send the data to ntop. I am looking primarily for top talkers data. Does anyone know how to config the cisco to do this? Possibly have a sample config? I have read about rmon, but...

wshuffman by Level 1
  • 1065 Views
  • 1 replies
  • 0 Helpful votes

Hi,I have a site with a cisco 2811 connected to 03 cisco L3 switches (3650) and I would like to monitor the switches by SNMP from my NMS. The problem is that the cisco 2811 is configured on a public IP and the switches are configured on a private IP ...

I am trying to understand the difference between adding an ACL to an interface with the ip access-group in ip access-group out statement. I have 'in' on one interface, and 'out' on another, and they seem to behave differently. Both of the interfaces...

t.khan by Level 1
  • 115984 Views
  • 1 replies
  • 0 Helpful votes

I have got all the latest software installed on the Ciscoworks server and RME will not back up the config on the 2960 switches. It keeps saying check that the correct device packages are installed. All the device packages that are installed say tha...

unilever01 by Level 1
  • 1542 Views
  • 10 replies
  • 0 Helpful votes

I am using a 2801 IOS 12.4(9)T with a VWIC-1MFT-E1 card in it. It is being used with CCM 5.1 for inbound and outbound dialing.I am trying to graph the total outbound and inbound calls over a given period and have been querying card by walking using O...

Review Cisco Networking for a $25 gift card