Network Management

I'm doing a clean-up on several switches, but i'm, unable to remove the following line :snmp-server view vlan1filter ccitt includedCan anyone help me ?

What is a SYN Cookie ? Mark all that are true. A marker left to identify a TCP connection The 3-way TCP connection establishment A way to mitigate against SYN flood attacks A specific initial sequence number Information encrypted in an...

Which of the following are vaild SNMP operations: get get resonse get next get next response get bulk all of the above

In Ciscoworks version 2.6 I am tring to get the local user and the AD user ID to work together to allow me to give the AD user permissions. The distinguished name format(lastname\, firstname) is not allowed as a local user. Is there any way to change...

Hello! I add device in Device and Credentials with IP, hostname, domain name and credentials for snmp. Then add it manually to DFM. But DFM shows this device only by IP address. As I know it must use DNS name if it possible to resolve device in DNS s...

Hi all,I have the following two questions.1. Upon rebooting a router do the created probes expire? Even the ones set to an unlimited lifetime. 2. Is there a description MIB for CAR mibs. So we can relate an entry in the ccarConfigTable to an actu...

Hi Guys,Currenlty I use CiscoWorks and Concord for network management and monitoring. I've been given the task to getting a cheaper tool to do both.Preferably one that does both. Have you any suggestions. A tool that allows me to make config changes,...

Hi,I have been noticing recently that the MAC addresses in the UT table are not updated. Today I ran the UT Acquisition from Campus Manager manually and then looked for my PCs MAC address in UT table. My PCs MAC was there but "Last Seen was July 2006...

router 7200 don't send NAT logs into syslog-ng. All other logs (for example enter in config terminal...) send normally. I have configured my router following the instruction: http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_cha...

Hi all,I'm fairly new to NAMs and I have what should be a simple question.I have switches at the centre of my LAN core, the core is Layer 3, so all routed interfaces.These switches are configured with multiple routed interfaces and use a loopback add...

Has anyone successfully setup and run SNMP queries using Windows XP WMI SNMP?I have attempted it but with no luck.Here are the steps I have performed;1) Added SNMP Protocol and WMI SNMP provider via Control Panel2) Created an SNMP Namespace in the WM...

We have two customers sharing a BBSM, and they want to use it for auditing guest wireless access. For several reasons these two customers want separate sites and separate subnets for their wireless guest, but they share a Catalyst 6513 as the switch/...