Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

I am wanting to setup a system where all my cisco devices (switches, firewalls, routers) will contact a central database to authenicate users so that we dont have one password for everyone and we can track who is doing what. I was told I can do this...

wrwiii122 by Level 1
  • 915 Views
  • 1 replies
  • 0 Helpful votes

HiI have upgraded the LMS 2.5.1 to LMS 2.6 .I am now trying to install the Device Fault Manager package.I have with the original cds the 2.0.3 . But i get an error message saying ERROR: Downgrade not Supported. Version of dfmad2.0 to be installed is ...

pmet by Level 1
  • 1238 Views
  • 4 replies
  • 0 Helpful votes

Hello everyone.Does someone know why can't I access this table?C:\>snmpwalk somehost .1.3.6.1.4.1.9.9.276.1.4no MIB objects contained under subtreeIs there some magic command to enable these variables? Because the router surely understand this OIDsom...

bella by Level 1
  • 1161 Views
  • 2 replies
  • 0 Helpful votes

I did some basic snmp monitoring to see what my utilization is on some routers. I would like to be able to break that down by the type of traffic, in high utilization spots. (just the wan links) If I do a#ip flow-cache timeout active 1#ip cef#ip flo...

preston by Level 1
  • 5313 Views
  • 5 replies
  • 0 Helpful votes

Hello,I'm running LMS 2.6/RME 4.0.5. Right now, it appears that the ASAs still aren't supported with the latest version/patches. I read somewhere that ASAs were supposed to be supported by the end of the year. Is there any validity to this? Is there ...

s-daly by Level 1
  • 973 Views
  • 1 replies
  • 0 Helpful votes

Hello. Once I have discovered that Campus Manager -> Topology Services in LMS 2.5 began to show the bigger part of my Catalyst 3750 to VG224 connections with red dashed lines (the devices are shown in green and are controlled normally). Catalyst 3750...

p_kiselev by Level 1
  • 1012 Views
  • 1 replies
  • 0 Helpful votes

for ciscoworks LMS 2.51) why in config editor -> Job Schedule their is "execution" tab (used to set the order of device deployment) by logic it should be used in netconfig where you can deploy to multiple devices, not in config editor to where one de...

Unanswered Topics

Review Cisco Networking for a $25 gift card