Network Management

Hello,I have on Cisco Soho 97 adsl router. I have set a dhcp server like this:ip dhcp pool Test network X.X.X.X Y.Y.Y.Y default-router Z.Z.Z.Z dns-server A.A.A.A B.B.B.B domain-name test.com lease 7 With this settings my PC doesn't get any ...

Not sure if this is the correct fourm, but i will try it. I am trying to direct ssh traffic to a specific server on my network through my 2811 router. When a remote client attempts to initiate a session with the server the get the login for the rou...

For some reason an engineer before me uninstalled DFM from Ciscoworks. Now I want to re-install it but the only disc I have is for DFC 1.1 (Common Services 2.2) and I get all kinds of errors. How can I get DFM back?

Hi,When I generate a device list report from CS I notice a lot of unknown devices. Most of these unknown devices seem to be our 2821 routers however cisoworks seems to recognise only a handful of these 2821s? Say for example when I'm making a netconf...

Hi,from some devices it is not possible to fetch config via. Telnet. Device is UP and reachable, credentials are verified and correct. Telnet timeout is set to 60 seconds. For most of devices Config Archiving works but for some of them not. I can see...

Hi all. Can anyone help me determine the port utilization on a serial port for a 3640 router? When I do a show interface..I can see the in/out packets. Can someone offer me some pointers and threshholds?thanks

Hi, I configure netflow in a Cisco Catalyst 3750, but it doesn?t work.The commands that I had used, are:ip flow-export source Vlan52ip flow-export version 5ip flow-export destination 172.26.101.160 9996interface vlan52ip flow ingressWhat else have I ...

Hello,Recently we installed some C1240 AP's, unfortunately in Ciscoworks they are not recognized as AP, they remain in the section unknown devices. When I try to download a device package, Cisco responds that there are no packages availabe, what can ...

Hi GuysDoes anybody happen to know whether running LMS 2.6 and ACS 3.3 on the same box would be a TAC supported Configuration ?ThanksLeon

Hi,I'm running Ciscoworks LMS 2.6 with RME 4.0.5.Since upgrading to LMS 2.6 all Inventory Scheduled jobs fail and all manual update inventory jobs fail with the message:ICSJ0008: Request to collect inventory failed. I have stopped and started the ICS...

Hi, I am using Ciscoworks LMS 2.5 on Windows 2003 service pack 1. Since last week, I am not able to use Device selector any more from all Ciscoworks components (e.g Common Services, Device Troubleshooting, RME etc....)Could you pls help us to trouble...

A new port-channel shows up in "show etherchannel summary" and is visible to SNMP, but is not found in either running- or startup config. None of the physical ports in the PO has been configured either. What could cause this to happen?sh etherc summF...

Hi all,using DFM 2.0 i'm unable to collect the status of polling parameters on any device. In Interactor.log you can see:25-oct-2006|14:43:21.672|ERROR|vhm.interactor|Thread-8| | |.|InchargeAPIWrapperImpl::getValue():: failed because SmRemoteExceptio...