Network Management

Hello,Is there any command to see what SNMP version is running in a router? Or how can I find out?Thanks in advance,Oscar

I have a customer with LMS 2.5 installed (on a Windows 2000 Server), running the latest patches etc. I have imported all the Cisco devices successfully. DNS does not have all the device hostnames but the LMS Server has a local hosts file with all t...

I'm having some problems getting a Siemens application and a Cisco IOS FTP server communicating. I think it may be because neither has implemented RFC959 correctly. My question to you is about the Cisco IOS server.I'm using the Cisco IOS server i.e.:...

Hi,Have anyone used Ipswitch WhatsUp Professional NMS for monitoring Network devices particularly monitoring WAN links . I'm planning to install the evaluation copy and see how it works. Input from the professionals who used this tool will be greatl...

I would like to limit an FTP traffic to either 256kbps or 128kbps transfer rate. Is there a way or QoS CLI command I can use to implement on the router's interface? or do I have to use 3rd party traffic shaping tool.Thanks

Hello,i found a topic which descripes to purge all LMS2.5 data back to zero on windows. Can anyone describe how this can be done on Solaris ?

I'm looking for a MIB that allows me to get the compression ratio that is part of the output of "show compress" ...show compress...Compressed bytes sent: 317862131 bytes 61 Kbits/sec ratio: 12.870Compressed bytes recv: 221975672 bytes 43 Kbits/sec ra...

I am currently running LMS 2.5 on Windows 2003 Server. The server has 2-3.2G Xeon's 4G of RAM and 216G of Hard Drive space. While I am on the server I go to task manager and look at the performance and the processors are not being used hardly at al...

Hi,what's the first step to do to begin to work with LMS 2.2 after the installationthanks.

Hi, I have some questions concerning the process of troubleshooting the hardware perfomances of routers.At my company I have to deal with some routers that have crashed during normal operations.Sometimes I can guess what the problem is by checking t...

when I type Show Log, I see a lot of "Nov 21 05:59:03.586 UTC: %AMDP2_FE-3-UNDERFLO: Ethernet0/0 transmit error"can someone explain to me what is the message means ? Is this suggest that the Ethernet interface having too many traffic ???Please helpBe...

can any one help me with OID code for getting CRC error notification in MRTG?Thanks in advance..

how to calculate the percentage (or threshold) of the broadcast storm need to be block for c2950 switch? e.g I have a 100M FE port has an average of utilisztion of 50Mps,should set it to 50%?

Anyone know if there is a script you can use to configure a master/slave setup for CiscoWorks (Common Services 3.0)?Thanks.