Network Management

I'm looking for some guidelines and best practices to configure logging on IOS devices, Fastswitch and Catalyst switches. I also want to configure the devices to send the messages to a syslog server.

I am the IT Manager of a small network.We use Cisco Catalyst 3550 switches as well as 2950 switches.I have configured these boxes to trap back to our manangement station for environemtal concerns. I have the following config on the boxes.snmp-server...

Does anyone know is there change to get only list of devices which current startup config and running config is not same.(running config not saved)

Device discovery will not complete (status running all the time). I have stopped CW Deamon manager, replaced CSCOpx\campus\etc\cwsi\DeviceDiscovery.properties file with DeviceDiscovery.properties.orig file.Started discovery with only one seed device ...

Hiiwhen you extract the field snaPu20StatsActLus, I exspect to get the number of active LU sessions , instead I get maximum LU session , Does anyone know where in the mib's to find the number af active sessions on at PU ?

Hi, I'm thinking of recovery steps for a NAM.Can it be recovered if the hard disk fail ?Is it possible to take out the hard disk, put into a PC and clone an image using Acronis Trueimage ?Regards.

Our site has been using CiscoWorks RWAN/RME etc since 2000 and are perhaps 12-18 mths behind in upgrades. It looks like the product has been obsoleted now, and I need to understand what the upgrade path for this product is.Is there any clear documen...

Can anyone tell me what I can do to fix this issue.2005/08/15 15:25:30 EvalTask-Devdiscovery-05 WARNING DevdiscoverySMFGetDeviceType: SNMP unreachable device at: X.X.X.X will not remap SMFFactory

Anyone have anysuggestions about any good managment software that doesn't cost an arm and a leg?

WHat is the difference between a managment Vlan and a native Vlan?

This is LMS 2.2 with IDU 11s of RME and Campus Manager:Following the database restore last Friday (using $NMSROOT/bin/restorebackup.pl), here're what's working and what's not.Working:1. Most RME reports under 24-hour Reports.2. Can delete devices fro...

RME database got corrupted. Tried the usual trick of /opt/CSCOpx/bin/restorebackup.pl -force, but just noticed it begins with:internal error: glob failed at /opt/CSCOpx/bin/restorebackup.pl line 293.***************************************************...

I am relatively new to ciscoworks, so if this question has been asked before I really apologize.I am running into a scenario where I see the MAC addresses of almost 95% hosts/network devices but IP addresses for only some of the devices in UT reports...