Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Insider User Research program

Labels

Forum Posts

I am trying to do a Change Integration Option on the Ciscoworks 2000 Server. When I get to the Choose Adapter, I select NNM Adapter, as that is what I have installed but it comes up with the following error.1. A small blank box with no name or title ...

londint by Level 1
  • 2906 Views
  • 1 replies
  • 0 Helpful votes

Hi, I got a device stuck in "Not responding" state when it was added to RME (CW2K 4th ed.) since this is a development server I want to delete everything and restart with a clean database, however I don't want to reinstall the whole thing. Problem...

carlosv by Level 1
  • 2952 Views
  • 3 replies
  • 0 Helpful votes

our site disable ' ip http server " , because it has a security problemWe bought a ciscoworks (LMS) at these day.I saw a document about CMSIf I use a CMS, we must enable "ip http server".Is it a correct?. We must eanble if we want to use it?Please an...

syjeon by Level 1
  • 2967 Views
  • 1 replies
  • 0 Helpful votes

what is the important configuration?am i configure below that?cdp enable in all cisco device.only cdp enable in device, is a possible to discovery a device?I have a 6509, and 5509 backbone switch.which is prefer seed device 6509 and 5509?help me.

syjeon by Level 1
  • 2976 Views
  • 1 replies
  • 0 Helpful votes

Hi,According to the Process status, ANI server is started, BUT when you click to analyze ANI server, we get the following error:AniWrapper>>analyze(SYSTEM) Server Named: ANIServer4.2-alfcwXXX on port: 14004Nothing has been done on that server. When i...

Hi,I have deployed a CWK2000-LMS in my network.But I found that I couldn't saw neither my WS-X6582-2PA installed in 7609 or multi-ppp links of my network in my CWK2000 platform. Could you give me some solutions? Thanks a lot.Sincerely

shan-cao by Level 1
  • 2917 Views
  • 1 replies
  • 0 Helpful votes

DearsHow can i monitor the WAN traffic (POS) with the NAM. I have done all the required configuration in the manual, Cat6500# configure terminal Enter configuration commands, one per line. End with CNTL/Z.Cat6509(config)# access-list 100 permit ip a...

In the User Tracking, the PortName field is all empty. How do I get it to show up automatically picking from with the CiscoView Label or directly from set port name on the Switch?Thanks

londint by Level 1
  • 2960 Views
  • 2 replies
  • 0 Helpful votes

I added new package devices in my ciscoworks installation because it doesn't recognize some new switches that we have acquired recently.After my update, I can see the switches with ciscoview but I can not see them in topology services. What can I do...

rbbb by Level 1
  • 3036 Views
  • 2 replies
  • 0 Helpful votes