Hi, Can someone pls help me with TCL script using tracking for shuting down every interfaces under router hsrp? RP/0/RSP0/CPU0:NPE3#sh run router hsrp | i interfaceMon Jul 20 14:15:19.627 CETinterface TenGigE0/0/0/22.1036900011interface TenGigE0/0/0/...
Forum Posts
Could anyone point me to the gui section or specific command to add a banner / security message for the Array. Not able to see it in the cli, gui or find it on internet.
I have the sub net 192.168.7.0 that contains 4 routers the .1 ,.2. ,.6 ,.251 connected on a switch.The 1 2 and 6 are backup roots (with the 1 as main) and the 251 is the bridge(firewall). So i have the 1 2 6 connected with the above routers with bgp ...
Is there any way to run CCP on Windows 10?
Hi Team,I have a 4507 cisco catalyst switch that is in vtp transparent mode and i want to delete the vlan.dat can someone help with the commands since i'm having issues with one vlan thank you.
hi i configured the reference bandwidth to 10000 and i have i gig link and one fastethernet link and both of them still cost 1 !router ospf 1log-adjacency-changesauto-cost reference-bandwidth 10000network 172.16.0.0 0.0.255.255 area 0 thanks for the...
Hi all, I'm implementing a new Cisco Prime v3.7I've seen there's an option to create a group-template for the purpose of configuring multiple devices with the same configuration-template but for some reason when trying to deploy the configuration i c...
Running 3.8 and when I get alarms like interface threshold limit violations from Auto Monitotring it lacks an interface's description.Is it configurable?
Running 3.8 and cannot get configurations out of 5550 (timeout) and 5506-X (could not enter ENABLE mode on device).Devices are monitored properly.
can someone confirm and tell me if OSPFv1 in CCNA 200-301 (i know we have OSPFv2 but im not sure about v1) thanks (:
Running 3.8 and looking for a way how to send SMS if a particular event/alarm occurs. I have only two options how to do it:1) if a alarm occurs then execute a script on Cisco Prime2) if a alarm occurs then send it to (my) syslog SMS gateway is standa...
HiI am new to this forum and I am not an IT expert.I purchase a Catalyst WS-C3560G-24PS-S PoE-24 and I have downloaded and installed Cisco Network Assistant 5.8 (9.1) (cna-windows-k9-installer-5-8-9-1-en.exe) for Windows.Problem is that my Switch is ...
Hi all,We have a Prime Infrastructure 3.3 HA Cluster (automatic failover type) with the following problem:In the Health Monitor of the Primary server we get Status "WARNING" and see:State "Primary Failover" and message: "The primary failed and hence ...
Hi ALL,I'm running into an issue where in I'm not able to connect to the console port of a FortiAuthenticator, FortiManager and FortiAnyalzer. The connection to these devices are via a 2900 Series router.
