Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Resolved! output flash normal?

I'm ccna student.  And on the routers in our class if you command show flash: to me they look polluted.I dont know if the output is normal?  Does a default out of box router/switch has so much crap in its directory?On some routers in our class, there...

Appelsapje by Beginner
  • 1142 Views
  • 3 replies
  • 0 Helpful votes

N9K syslog server configuration

hello,syslI want to send the log message from n9k (version 6.1(2)I3(4b))  to syslog server. I do the configuration as follow:interface mgmt0  vrf member management  ip address 10.8.91.31/24logging server 10.8.0.103logging server 10.8.209.80logging se...

Jack Chen by Beginner
  • 1199 Views
  • 2 replies
  • 0 Helpful votes

eem causes router crash

hiI have a 4431 with IOS 15.4(3)S6a which works well.A cisco engineer advises me to upgrade in 16.5.5 so I did it... but router crashed. In checking crash file, it seems to be one of my EEM script that crashes router after the reload command, see bel...

nvanhaute by Beginner
  • 1221 Views
  • 3 replies
  • 0 Helpful votes

Resolved! Tcl/EEM with IP SLA tracking down/up

Hi I'm wondering if a .tcl file would be run automatically each time a tracking state for an IP SLA (icmp-echo) changes from/to up/down? Based on some research, something like (I can't test if this works because Tcl/EEM doesn't work properly with rou...

acisco by Beginner
  • 3100 Views
  • 9 replies
  • 0 Helpful votes

Telnet/SSH Cisco SG350-28 issues

I have a Cisco SG350-28 switch I have configured,  It's the 2nd switch in line of my route switch. I used to have connectivity to it until a 3rd party installed a new piece of equipment on my VLAN.I can ping the switch (10.2.3.3) through my firewall ...

gmcclain63 by Beginner
  • 1715 Views
  • 1 replies
  • 0 Helpful votes

Resolved! VTP Issue

I have a switch that has several devices on it.  these devices are in 4 different vlans.  I went to move a cisco wireless access point into a different vlan, a vlan that no end device was currently on.  when i did, it said the vlan did not exist on t...

Rebooting multiple APs via Prime

I'm looking to use a cli script in Prime to reboot a certain group of APs late at night. I've tried:#INTERACTIVEconfig ap reset AP01 <IQ>y/n<R>yconfig ap reset AP02 <IQ>y/n<R>y...#ENDS_INTERACTIVE Which works fine for the first few on the list, but e...

Communication Delay between Vlans.

Hello all. I work in a Public sector. Now here i am facing an issue for quite a long time. There are three Vlans(201,50,32). On Vlan 32 there is a reports portal server which is used to update the daily reports. When i access the reports server from ...

FAZ by Beginner
  • 1145 Views
  • 2 replies
  • 0 Helpful votes