Network Management

We have a Nexus 9000 N9K-C93180YC-EX deployed in our lab environment on NX-OS 9.2(2) version.Our Network management product fires a snmpwalk query to get SNMP data from the switch.Noticed that in response to snmpwalk query we were getting garbage val...

Hi,I'm trying to update the image of the device software via epnm. The only step I still have to do on the device (CLI) is: squeeze flash: The EPNM can: (delete the smart flash before distribution), but does not squeeze the flash and therefore still ...

Hi All    I want to enable VPN on my ASA Server, it had configure SSL VPN , and Because the default port conflict ADSM , so I mofigied the SSL VPN Port from 443 to 4443.    after setting , I could see the AnyConnect Web Portal from Local LAN , but I ...

Hello all, I am working on a Cisco Prime 3.7.0 Deployment and i have got some issues regarding AVC Deployment using Easy Performance Monitor.I have pushed the configuration for AVC Monitoring towards Branch Routers, yet i have run into an issue when ...

I have two 2821 cisco routers im currently using for my homelab. Yesterday i was configuring the first one, i swapped the console cable to config the second one and when i swapped back to the first one it didnt respond at all. I rebooted it, tried al...

After a long time with Telnet still available on our network switches, I started deploying a CLI that disabled telnet. Just after I started going through the school sites, one at a time, I realized I had neglected to check mark " Copy running config ...

Hi,I'm trying to add CoS classification to traffic coming in from access ports that are on vlan 2551.  I did a match any with VLANs and access-group match statements to see if I got any hits.  The policy-map stats for the example interface are below....

I have implemented secure logging on our Cisco ASAs via 'logging host ip.address tcp/6514 secure' and then adding the proper certificates. For the switch I have tried "logging host ip.address transport tcp port 6514" and i have the proper cert instal...

Hi to all, as i was looking in two of our switches i found out that Prime "decided" for the first switch to assign a VoIP Phone port as link port and in another switch which had exactly the same configuration in the voip port as the first switch , Pr...

4331 router with ucs-e140s module.  Ran a session from CLI in the router. Now at the "CISCO-IMC login:" prompt. What's the command to get out of the session from there?  Ive tried Ctrl-Z and Ctrl-Shift-6 x with no luck among others. 

I have the problem of the DHCP handing out the old DNS entries in Cisco Router IOS-XE. There is no DHCP server configuration in the router but when i run the command show dhcp server it gives me the old DNS entry which i configured last week and remo...

been searching the KB but can't seem to find the the correct reference is the throughput level in isr shared between ingress and egress? if i have 400M throughput will be shared inbound and outbound traffic or dedicated  thank you

Hi All, I have IPsec crypto configuration available on one of my router. Crypto map is configured with local-address command with WAN interface. But crypto map is not applied on any interface. As per my knowledge, if crypto map is not applied on any ...