Network Management

Hi all I try to connect to the GUI of the WLC 5520 over the management interface. The management interface has following ip: 10.123.6.181Ping is working.But i cant access GUI over this IP address. Following network Configuration:(wczhlab01) >show net...

Hello!I have this network scheme: SwitchA -> SwitchB -> SwitchC -> Wireshark. Ports between switches is Gi0/1 in trunk. SwitchA(config)# monitor session 1 source interface Fa0/1 - 24SwitchA(config)# monitor session 1 destination remote vlan 10 Switch...

i am not able to go to net academy class 

Hello,I'm setting up a datacenter scenario with redundancy on a contingency site. We will place two Catalyst 9407 switches in the CORE layer, one in each datacenter, using the Stackwise Virtual Link (SVL) concept, in order to use the Etherchannel Mul...

HI, Can any one share the CPI ops document which will cover SSO configuration between CPI-OPS and CPI client. Actually  I have document of CPI-OPS SSO configs, but i dont know what to configure on CPI client. regards

Trying to install a brand new RV340 using set up wizzard. Dynamic IP setupThe router will not pickup the IP and the technician on the supplier end can not see the Router.If old router is used to "open the connection" the router indicates that it is c...

Hello, i am trying to make an EEM script to extract IP address from ACL log then check this IP against a .txt file that has all whitelisted IPs and if no match is found an ACL term is added to block this IP.I am able to make the script that extracts ...

Hello, Still a new network guy here. Our organization is interested in changing the current 192.x.x.x ip addresses to a 10.x.x.x scheme. I have given interfaces IP's before and created DHCP pools before in labs... but I have not transitioned an exist...

Hi Everyone, I  Have 3750 48 PS V2 which I installed a month ago and configured, it has been working fine but all of a sudden it just went off yesterday. There is a small flicker of the front led lights when you power it but just for a split second t...

Have a very basic question regarding Site to Site VPN Tunnels... Is it required to establish tunnel at the same time at both locations ?  i mean can one location configuration be done on one day and the other side configuration can be completed the n...

How many PAT we can do with a single global IP. ip nat pool NAT-POOL 1.1.1.1 1.1.1.1 netmask 255.255.255.252ip nat inside source list 101 pool NAT-POOL overload

Hi, I am currently in trouble with configuring MAC authentication correctly. When I connect my computer on the port, the port has vlan 999 which is fine. The computer is compliant and he gets the vlan 1 to access the network.  When I disconnect the c...