When I try to upgrade the switch stack, I get the error:XXXXXXXXXX#$age install switch all file flash:cat3k_caa-universalk9.16.12.01.SPA.bin new auto-copy
--- Starting install local lock acquisition on switch 1 ---
Finished install local lock acquisi...
Hi everybody,I just purchased a new RV134W for my home. I have to manage serveral devices on my LAN, such as IP cameras, VoIP phones and some clients.Everything seems to work fine except for some stucks on the net. Checking the router's log I get a h...
Hello, my ISR4431 (Cisco IOS XE Software, Version 03.16.07.S) can collect netflows, but nothing is exportedI tried different sources interfaces, port numbers, no way .I think my problem is similar to https://community.cisco.com/t5/network-management/...
Hi All, As I know all the new switches 9x series switches uses the new ios-xe and support SD.I knew from googling that they support a better web ui, well, that's ok but...I am an old school and I am feeling much better with the cli, so the ques...
How do I apply different custom message lists to different syslog servers?from the documents (https://www.cisco.com/c/en/us/td/docs/security/asa/asa910/configuration/general/asa-910-general-config/monitor-syslog.html#ID-2121-0000048e) our network eng...
I have an old Cisco 2960. It was chained to an EnGenius switch. Cisco > EnGenius > Host. If I connect the Host to the 2960, I cannot ping to or from it. This persists even if I remove the port from the local VLAN, 192.168.1.0. Port is set for access ...
i use 50 cisco switches in the enterprise network i want turn off the Switch access ports or poe ports in the night what is software can help me ? cisco energy management server ?how can i download and buy cisco energy management server license ?
I am a total noob and I am really getting frustrated as the days goes by. We just recently moved into a new location and I as the head of IT was called upon for the network infrastructure. We settled for 16 Cisco SF350 Managed switch and a Mikrotik ...
Hi everybody,I'm trying to configure my Cisco 1113 to work with italian TIM Vdsl2 FTTC. Unfortunatly it doesn't work and I'm trying to find where the problem is.First of all, here are the requirements of the ISP (TIM):- Vdsl2 with spectrum between 8b...
H there. I'm racking my brains trying to think of the most simple solution for a ~100 employees organisation that connects to two sites. I have to be able to simulate this using Packet Tracer. Plan is to use an IPSec tunnel VPN between Site A and B. ...
New to this. Trying to setup an old AIR-LAP1142N-A-K9 access point. I'm in the console port with putty. Unabel to set IP address, because the port keeps outputing lines infolike this"Translating "CISCO-CAPWAP-CONTROLLER"...domain server (8.8.8.8)*Mar...
Hellow there, I am Harish from hyderabad and i had multiple devices which are out of support cisco conference station 7937, I wanted to connect my device and work so am trying to download unified manager to connect and its not downloading can you peo...
Hello, Specialist.Can someone clarify the error message below? This is a Cisco 2901 router. platform-5-ecc_msg a corrected single bit error has occurred in dram at location 0x30197FB0Thank you very much.
