Network Management

Hi, how are you?I need help , with connecting my server pc to ethernet i can see him with the WIFI , but if i connect my server with WIFI , i cant see my server and my pc.If server is with ethernet , i can see this pc too. Im using a CISCO RV 340W , ...

I have some licenses available in PI, but when I try to add a switch I get , " No valid device is selected to change admin status "  when it is in the unmanaged state, after adding it. One of these would tell me , before I could add it,  that the IP ...

In the device rediscovery process I'm experiencing inconsistent snmp collection results.  At one time or another22 devices (3750,3850,4500 switches and 2900 and ASR1001 routers) have been successfully discovered/rediscovered by the PI, only to later ...

Hello Everyone, I'm looking for input on best practices when it comes to updating firmware. I've been tasked with writing up something of a schedule to follow so we can work towards staying current on our network device images. My initial though woul...

good morning I have this report from users, saying that they encounter connection issue only when they are wired , but the wireless I fine. both connection are using the same path to the internet ...please advised a troubleshooting plan.

I am getting error Failed to get configuration from device. Check if the startup configuration(command: "show startup-config") is present on the device or the start-tag(!) is available in the configuration. while using "Configuration Archive" option ...

Hello Team, We have below Script running on our ISR 4431 router.event manager applet TUNNELDOWNevent syslog pattern "Line protocol on Interface Tunnel1, changed state to down" maxrun 60action 1 cli command "enable"action 2 cli command "conf t"action ...

I would like to query all of our switches to see if a setting in saved correctly and I hoped PI would be able to do it. For instance if I want to insure that all the enable secret lines are the same. Can PI do this or is there some sort of scripting ...

Hi all,Please refer to the Network Topology attached. I tbh dont know the VMware architecture too much but the way I have connected these guys, everything is able to ping each other and so the connectivity between them seems fine but for HA I dont kn...

Hi All,I have a question about Cisco WLC 8.5 and ISE 2.3.Can I to do accounting from WLC to ISE via RADIUS without authentication?On WLC, I have local user database (net user) to web-auth and I want to send any trace to ISE (user id, ip address, MAC....

Hello. I’m try to connect through IPsec RV130 VPN Server via iPhone iOS 13. I have some trouble (see attached)What mistakes do I make? 

We have a number of pseudowire tunnels established on our routers to pass serial data from some older manufacturing equipment that uses RS232.  We are routing this traffic using xconnect and L2tp over pseudowire.  This works fantastic except we are u...

I don't know if I am posting in the right section, so forgive me if I am not! I am using an RV320 to connect the systems at two locations over a VPN. It was working just fine for months, then the internet became slow, the connection became shady, con...