Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Resolved! Juniper and Cisco

I have two switches 1-Juniper 2-Cisco SG300 My requirement is in juniper side i will use SFP module and Cisco side also ,but both are different vendor so how i will configure that port. I did 1-Both side "trunk" 2-Set Full duplex 3-Allowed all vlan i...

telnet session closed automatically

Hi everyone,     I have a problem that is telnet to router 1841.The telnet session will be disconnect after i login the device.even though i don't anything.     I have run Wireshark to capture,i can see there is a tcp RST packet from router to PC.But...

Rps-Cheers by Collaborator
  • 2329 Views
  • 6 replies
  • 0 Helpful votes

Resolved! Bad Power Supplies

Hello, I have a stack of 5) 3750 X switches and they have 2) 1100WAC power supplies per switch attached. I have 2 power supplies that are showing bad on lets say switch 2A and 3A. I am trying to find out ...1. Is it ok to pull the bad power supplies ...

Resolved! TCL ios_config

Hi all experts.If someone can help me with this i will be really grateful.I am currently using rancid for my devices backup and custom configuration upload. I found it to be brilliant.Recently i had a task, that involved getting the ip address and tu...

Jonn cos by Enthusiast
  • 4238 Views
  • 4 replies
  • 0 Helpful votes