Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Dear All,one of our Catalyst 2960S switches had a stack member outage last night and we can see an event in Cisco Prime:"CEFC FRU Removed" - "Stack Removed". Alarm detected through switch. Where can we see if this event was triggered by a syslog or i...

Hi, We are experiencing issue on Cisco Prime 3.1,We have a WLC 2504 and AP 3802 8.5.135.0The WLC was reachable and the AP information in Network Devices was good. But in Maps, the AP shows grey-out with question mark and when I search for the meaning...

jorogan by Level 1
  • 2908 Views
  • 10 replies
  • 0 Helpful votes

Hello,Attached is my PT file. I have tried and tried but I cannot get my routers to find each other using eigrp and this, I believe, is causing me to not be able to ping across sites. All of my subnets are the same, /24, I have loopbacks established,...

Hi guys, I am performing the command "show controllers VDSL x/x/x" in an ISR4300 to verify CRC and Header error counts. I noticed the values increase but also decrease over time. What would be the reason for the error count to decrease? Ps.: No type ...

JoeyJoe by Level 1
  • 2453 Views
  • 5 replies
  • 0 Helpful votes

Hi, I wonder if anyone can shed some light on this, I want to offer the Webui to our local teams to access their switches if they need to troubleshoot or locate a device (Phone/AP). Whilst testing as level 15 Admin I can see the CDP Table populated s...

Hi all, Currently we have configured CoPP in our Cisco ASR 7606-S in following way (According to a template we found from Cisco site), but it has not been applied so far in the control plane due to some issues. Now our team decided to apply it in the...

Review Cisco Networking for a $25 gift card