Network Management

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

snmpv3 security

hi guys,   I've got a basic question about implementing SNMPv3... how should the design regarding the security parameter e.g. username/authentication- and privacy key look like, I mean should they be different on each device or group? I'll appreciate...

AP "stuck" in Prime

Running Prime 3.1 MR6 Update 1 DP11   Had an AP (3702, driven by a Wism2) fail in our environment. Another AP got the failed AP's IP address. Prime now shows two AP's as registered. Both have the same IP but different hostnames. The controller does n...

Y C by Beginner
  • 4 replies
  • 0 Helpful votes

IOS-XR NETCONF edit-config question

Thanks in advanced for your help.  I am working with a Cisco ASR9001, software version Cisco IOS XR Software, Version 6.0.2[Default]. I've been able to connect via NETCONF over SSH and perform basic NETCONF commands. However, I am running into unexpe...

mmessa by Beginner
  • 2 replies
  • 0 Helpful votes

Resolved! Changing vlan on interface with Cisco Prime Infrastructure 2.0

Dear all,I want to create a template for replacing vlan on some interface on lot of switch.i ve done this one : #foreach ($interfacename in $interfaces)interface $interfacename           #if ($Vlanid == $Vlanidold)                                  no...

DHCP 3750

We have a multiple dhcp pool in 3750 as I observed we have no of ip free but system not getting ip from them and getting apipa. After doing ip release/ renew then system getting ip so can you please suggest a solution how can we solve this problem. w...

yogesh1 by Beginner
  • 10 replies
  • 0 Helpful votes

Resolved! Redirecting TCL output to a file

Trying to use tcl to gather output from a number of show commands and redirect the output to a file.1. Is there a way to suppress all the screen output. I just want to show the output and none of the tcl commands.2. How do I send all the outputs (out...

rpeasah by Beginner
  • 2 replies
  • 0 Helpful votes

Resolved! Cisco Nexus Snapshot

The snapshot feature looks like a very interesting and useful feature to use but I'm having problems in two different boxes with different NX-OS versions, the error is basically the exact same error: I have tried in nxos.7.0.3.I6.1 and nxos.7.0.3.I2...

Screen Shot 2017-10-23 at 2.00.14 PM.png

ios kron system variables

Does the IOS kron feature have system variables we can use in commands it issues?I am looking to schedule a command (ephone-hunt statistics write-all url/filename) but am needing to customize the filename and was hoping i could use a variable to use ...