Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Need OID for rxload and input rate

Hi all,I want to monitor the rxload and input rate on interfaces but I can't find the correct OID can someone help me with this please.Can someone also provideme a good document for thisGigabitEthernet4/8 is up, line protocol is up (connected)  Hardw...

gurkamal01 by Beginner
  • 9179 Views
  • 6 replies
  • 0 Helpful votes

CISCO Network Assistant Topology View

Hi I have a quick question about the CISCO Network Assistant Topology View, sometimes when CNA discovers a new switch is Places it outside of the Topology window so you cannot see it?  how do I then drag and drop the switch to where I want to see it?...

jodan by Beginner
  • 2962 Views
  • 9 replies
  • 0 Helpful votes

DCNM MIB support

Hi everyone,   Can you know if the Cisco DCNM can read all MIBs supported by Cisco NX-OS (Nexus 5600)? I'm refering about MIB I, MIB II and private MIB.     Thank you very much!   Allyson  

apereira3 by Beginner
  • 992 Views
  • 0 replies
  • 0 Helpful votes

Resolved! IP SLA with Object Tracking PROBLEM

Hi, I have a problem with the 2 SLA that I am using to get EEM script and Failover.I have 4 tracks that I am ussing 2 for 1 SLA. My conifg is the next: ! track 1 ip sla 1 reachability delay down 6 up 6 ! track 2 list boolean and object 1 not ! trac...

farguisito by Beginner
  • 3817 Views
  • 13 replies
  • 0 Helpful votes

Resolved! DHCP Assignment Event

Hello all, Does anyone know a way of triggering on assignment of a DHCP address to a router?  Is it easier to catch it as a syslog event?   if a router is configured with: interface g0/0   ip address dhcp    ip route 0.0.0.0 0.0.0.0 dhcp

Resolved! Script to stop and start a capture point

Is it possible to write a script that would start a capture point and then stop it after 5 minutes and then export it to a tftp server, then again wait for few minutes to re-start the capture point and repeat the whole process again?   We need to cap...

cofee by Contributor
  • 1765 Views
  • 6 replies
  • 0 Helpful votes

Cisco Prime HA upgrade from 3.0 to 3.1

Hello,   I hope some one can guide me on the upgrade process.   We have Cisco Prime 3.0.0.0.78 on UCS appliance PI-UCS-APL-K9 and plan to upgrade to 3.1.7   I read, HA has to be removed first before upgrade, It would be great if some one can guide on...

saleem pc by Beginner
  • 1407 Views
  • 2 replies
  • 0 Helpful votes