I need to know that after configuring SNMP in a Cisco router how to import the MIB in the NMS to get alarms from the NMS.
Forum Posts
I have Prime compliance working to check to make sure the expected config is present. But how can I use Prime compliance to find additional config that is not needed? For example, I have a switch with the following config, and 'length 0' is not suppo...
I've attempted trying to find this and haven't been successful. Also please note this is my first forum question, so apologies if this reads incoherently. My team has two domain's we manage, each domain is a central site (small datacentre) and multip...
Resolved! Cisco Prime 3.5 (VA) HA Failing
Hi, I am currently trying to deploy 2 Cisco Prime 3.5 Virtual Appliances in HA mode, the primary device is setup and the secondary has been configured to be a secondary node. When I initialize the process to register the primary with the secondary I ...
Hi to everybody, I´m triyng to install a patch in Cisco Prime in order to make an upgrade but I cannot connect via SFTP to transfer the file, I have enable root access but I can´t connect with the server, I´m using root user password root_password an...
In desperation I added an ACL at the top of the list that permits all traffic from any source to any destination and the packet tracer still says that the packet will be dropped by the implicit ACL rule.I added the permit everything rule to my outsid...
From what I have read on line, it appears that by default the Nexus Switches, at least the 7k, has ifIndex persistence by default. Can anyone confirm this? Thanks!! Mitch
Can any one help out, How do I check the attempts that have been made to authenticate on there SSIDs ?
Hello everyone,Modules model:C6880-X = C6880-X-16P10G C6880-X-LE = C6880-X-LE-16P10GC6880-X module works on C6880-X-LE and vice versa. They are compatible each other? Can I use both modules on both chassis?Thanks.
Hello, My name is Andreus I'm new about Cisco, Would I like know if device rv345 support client ssl?In my case many people need access this vpn, so I want configure in my rv345.Are there any sugestion?
I have three switches connected in series. They are a 9300, a 2960 and a 4507. The 2960 is in the middle. The 2960 is connected to the 9300 by copper GB ports. The 2960 is connected to the 4507 by copper GB ports. All interconnecting ports are t...
I have looked and cant figure out how to do the following in a EEM file. If i have a command just as, action 1.1 cli command "show platform software status control-processor brief | append bootflash:/rpcpu1min.txt"How can i proceed this command with...
Hi everybody, Is there any standard or usual way to configure LAN equipment to put NMS packets in high priority? Base on RFC 4594, network control packets or telephony packets could have the highest priority among different classes. NMS is responsi...
How would one implement multicasting on a network where there is a L3 core switch routing multiple VLANs and several access switches connected to the core? I am a complete newbie to multicasting but the issue is that there are a couple hundred video ...
What sets Allot, Procera, Cisco, and Sandvine apart from each other in network policy management?
