Network Management

Hi   I configured an ip access list on our core switch for Print Management but since I applied the access list on VLAN 95 inbound and outbound I am unable to access the printers web configuration, where did I go wrong?

SpoilerCisco Prime 3.0 report Cisco Prime 3.0 report I was trying to see the Raw Netflow reports, which do not pull me out showing information, and it shows the next message. No data matches the specified criteria for the report.

Hello,Am christopher from TANZANIA (EAST AFRICAN COUNTRY).Please help me.we have our cable tv and we want to stream it to our another office in another region, where we have configured a VPN in this two offices using cisco router RV180. I have tried ...

what is mac address table fields and how a switch uses mac table for switching decision?

I'm Italian .  I would like to  ask this question .infrastructure ethernet over mpls  I lose packets  pinging   default gateway   router cutomer from the internet . pinging from router pe default gateway lan customer no loss of ping . any idea to sol...

Anyone know where I can find a users GuideThanksSteven

Hello Cisco Community,   I read that the minimum fields to determine a flow in Netflow is the 5 Tuple (SA,DA,SP,DP,PR). Now I read about flexibleNetFlow and that there is a possibility to define KeyFields. (IP (Source or Destination), Mask (Source or...

Hi Cisco ExpertI have some problem regarding about certain device type in Cisco Prime LMS inventory not available. I am using Cisco Prime LMS version 4.2.0. I have Nexus 7004 will be need to add in Cisco Prime LMS for monitoring but the model was not...

Hello,   we have 2 WLC 5508 and 5520 when we add these to prime, 5508 is added but  for 5520 we are getting error like "collection Failure", we followed the exact same steps as 5508, and troubleshoot the 5520 like removing from prime adding back but ...

Hi all,   I am implementing a pretty fancy menu in one router to give access to our monitoring staff to all our networking platform, the idea behind ths is to give a small and easy to understand menu to access our routers and switch in the branch off...

Hi ,   I have configured IP sla and EEM on catalyst 3850 to send an email alert when ip sla gets triggered. But, It's frequently keep sending email alerts even the ip sla is not triggered.   Please see below the configuration,     IP sla ------ip sla...

Hello All,   Currently we have traditional licensing for Cisco prime 3.3 , we gonna switch to smart licensing soon. is there any chance, in future if we want to switch back to traditional licensing. does it support ? or do i need to take any consider...

Hi, How to get the "show tech"output of the Cisco devices(Routers&Switches) which are registered in the Cisco prime Infrastructure 2.1.Please help me out. Thanks,