Network Management

Hello, When you have two interfaces configured on the PI-UCS-APL-K9, which interface is referenced when the Prime discovery process modifies "the device configuration(s) to add a trap receiver in order for Prime Infrastructure to receive the necessar...

Hello everyone I want to deploy a IP SLA that will be checked by EEM on a IE 2000 Switch to shutdown an interface I need to know if the IP Lite License could perform it or there are hardware limitations with the IP SLAs Thanks for your assistance

I'm trying to configure a 2960 switch to use public key authentication rather than a username and password.I create the private key and export the public and add it to the switch config using. (config)#username user1(config)#aaa authentication login ...

Hello,       Days ago I posted a discussion about the need for free TACACS+ system and thanks for the community I reached to tacgui tacacs server, free linux based, not bad but:If any one had an eye on this tacgui, it's working but I have cases that ...

I have several Cisco 2960 switches set up on our network. I also have them set up through the Cisco Network Assistant. When I look at the topology, I am not seeing the correct corrections. I have removed all VLANs from the topology other than default...

Hello,where do I change these settings of the 525g2:Proxy:  Proxy Port:  UserID:  Password:   thank you

I'm currently trying to setup management by REST API on a ASR 1004 router.  It isn't clear whether this is possible for the ASR 1000 series.  Please could someone help and confirm whether this is possible and if there are any resources available. The...

Hello everybody, On my ASR907 Router, with following software:Cisco IOS XE Software, Version 16.09.02Cisco IOS Software [Fuji], ASR900 Software (PPC_LINUX_IOSD-UNIVERSALK9_NPE-M), Version 16.9.2, RELEASE SOFTWARE (fc4) I can't achive remote L3 mirror...

I'm a returning student with not a lot of real world hands on experience (wasted a lot of time with things like GNS3), especially super legacy models such as the 2514 router, which is my current problem child. I purchased a stack well over a decade a...

Recently, I emulate an firewall (asav9121) in GNS3 with the latest asav9-12-1.qcow2 image. When getting information from device with SNMP protocol, I always get no response with snmp version v2c. It works well with snmp version v1.gns3@gns3vm:~$ snmp...

i have 4 access point in same floor with same ssid 5gh wifi connecting fine to devices but there is problem with disconnecting some time from client after some time and i have search on google and i try i lot of things but doesn't work this message a...

Hey guys, I have a small home network, where i would like to sent multicast (239.1.1.1) from Router 1 (Cisco 892FSP-K9, IOS 15.2) to Router 2 where Router 1 has PIM-DENSE Mode set. I would like to secure Router 1's network so no one can get into Rout...

Hi, I'm wondering how to get the MAC Address Table using SNMP on ASR920 routers. Is there any MIB similar the ones used for Catalyst Switches? e.g. BRIDGE-MIB and dot1dTpFdb Object-Type?  

Hi All, My Cisco prime license reports indicates that I have about 45 token available, however when I tried to add device it says that there are no licenses available. Is this an expected behaviour? Regards, Kanes.R