Hi I'm trying ansible for the first time and have meet some problems in getting the basics to work. I have a simple playbook that runs a command and saves the output in a file, but it won't work. ansible-playbook -vvvv playbooks/backup_cisco_rout...
Hello there, I'm getting an error when running CNA version 6.0. Thank you
Hi Team,We are using Cisco Prime assurance and are currently monitoring Cisco UCCE Components through it.Meanwhile we have few third party windows servers , which we would like to monitor it through Cisco Prime , just to maintain a single monit...
Hello all, I have a network with several Cisco routers. I noticed that in the past year, a number of devices sent out a message of "%PLATFORM-5-ECC_MSG: A corrected single bit error has occurred in L2C Data Cache at location" with different location...
What I'm trying to do is see if a file exists with EEM. There may be a better way to do this, but the way I have works, except when I try to use a variable for the filename. Below is the config without variables. It also shows the correct results f...
Hi, I work in an environment where a group of people will bring their network with them to train in a certain environment as sort of a team building and training exercise. For the most part everyone always brings cisco equipment. But every once in ...
I have a WAP4410N and I got the internet working nicely, but I can't access the web-based configuration utility. The manual says the address is 192.168.1.245, but Firefox (and other browsers) can't open it. I have tried pressing the reset button, but...
I want to configured Netflow on my Nexus 3548, would like to know is Netflow supported by Nexus 3500
I were given an IP address of 192.168.201.0/25 (2 subnets) And i wasnt sure how to find out and configure them on the PC This is the example given for Jurong Branch. Jurong Branch IP : 192.168.107.0/24 Subnet 1 Network ID: 192.168.107.0 First Usa...
Hi.I am facing the problem while deploying the Software image with cisco prime 3.1 I have attached the error I got after failure job. Is there a way to extend the timeout time on prime or is there any other way to correct this error? Please reply i...
Woodlands > 192.168.201.0/25(Subnet 1)Network ID > 192.168.201.01st Usable IP > 192.168.201.1 (Default Gateway)Last IP > 192.168.201.30BroadcastIP > 192.168.201.31 (Subnet 2)Network ID > 192.168.201.321st Usable IP > 192.168.201.33 (Default Gateway)L...
Issue - tftp'd over the new image. did the boot system flash etc to update the config but the old image is still in boot startup. how do I remove it? I have tried the no boot system flash etc then end. I don't get any errors buts its still ...
Hello everybody,I am trying to write a CLI Template in cisco Prime to save the running-configuration of our core switch to the FTP server, I have already configured the FTP username and Password in the core Switch ip ftp username ciscoip ftp password...
Hi all I am having trouble with my SSH lab. I have been able to SSH my switch when just setting a password for the vty lines and using the login command. However when i opt to use the login local command and ask for the vty line to grab the credentia...
We have a L2 Wan link terminated at 2960 switch and a 3850 switch. one end is client side RDS terminals and cisco phones and the other end are the servers. every now and again users at the client end complain that phones re-register and data connect...
