Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

Hi Team,   We found an issue with our Prime. It's running under 3.1 version. We are monitoring all customers network with Prime and few days ago one of the members of a stack of WS-C3650-48TQ has an electric problem.   Cisco Prime didn't notified any...

erikreig1 by Level 1
  • 2640 Views
  • 6 replies
  • 0 Helpful votes

Hi,    DCNM 10.0 supports the http protocol?     After deploying the DCNM10.0 ,we can access the DCNM WebUI using the "https", but not "http".    We had not seen any protocol related information during the DCNM 10.0 installation procedure, so that we...

Hello Experts, Please help with below scenario:   Background: I need to configure NAT on a C3900 router to retain original IP address (referred as Identity NAT in firewall).   Scenario: There is an existing configuration to perform unconditional NAT,...

 Hi everyone.   I have a customer that had Prime 3.1 and they got satisfying "Disassociated APs" reports from it. Now they have prime 3.2 which doesn't seem to be doing the same thing. It gives a too much detailed report not only the disassociated AP...

According to the instructions from Cisco, I need to1. set the laptop IP to 192.168.45.2/24 (check) # ifconfigem1    Link encap:Ethernet  HWaddr 34:E6:D7:53:45:D5            inet addr:192.168.45.2  Bcast:192.168.45.255  Mask:255.255.255.0          ine...

fmc1000.mp.png

Hello All,   Device: ISR4331/K9   I'm not familiar with "SM" slots on the ISR devices and I was wondering if someone might be able to tell me if there's anything plugged into the "SM 1" slot based off the show inventory command shown below?   # show ...