Network Management

Hello everyone. I'm doing research that is monitoring dual stack network using an application, and assisted with netflow cisco. And I want to give bandwidth to my client. how to set bandwidth in cisco router 1841?

Hi team,   My CPI 3.2 Instance is running very slow, it is also showing some CPU Utilzation around 85% but running normal now.   Please suggest what should i do to make it performance normal

helloWe use vrf in our network for separating user / production traffic vs management traffic. but the way we have used it has turned out to be messy and we are in a situation where we no longer have the distinction between the two. I personally feel...

I have a WLC 2504 installed using VLANs.   Currently the management IP of the WLC is on a different subnet than my main IT workstation. I have poked a hole from my workstation specifically to the WLC and I can ping it but cannot connect to port 80/44...

I have three routers where the Management interface was put into a separate VRF.They are all 2921s, running 15.2(4)M5, 15.3(2)T and 15.0(1r)M16.I have entered the command that I think is all I need to enable polling:     snmp-server host X.X.X.94 vrf...

After upgrading from version 3.1, CPI version 3.2 now uses notification policies which it has auto generated as part of the upgrade using the old notification destinations (email addresses) At the moment these policies do not work, User cannot delete...

This job aid addresses the tasks that you can perform by using the Chassis View to configure a Cisco NCS 2000 series optical device after its initial installation, which provides a good overview of one type of device management task that you can perf...

Just wondering if anyone know if Cisco Prime Infrastructure support the Cisco ASA.  I was doing some research but i couldn't find the license part number (L-MGMT3x-xx) for the Cisco ASA.  Also, has anyone was able to use the Cisco CCW website (www.ci...

Dears, I need help to figure out what is wrong with my EEM applet script : Am in need to send by mail the result of ping to different destinations, the script is as below: event manager session cli XXXX event manager environment _email_from XXXXXeve...

I have the below ASP config. But I'm trying to do much more. I've read through a lot of threads on this community but I still can't seem to get it to work.  macro auto execute SKYPE_OUI_MATCH { if [[ $LINKUP == YES ]] then conf t default interf...