Network Management

I am trying to set up a compliance in Prime infrastructure 3.1 and can't get it to work as i want to. I have the following examples of access-list: access-list 50 permit 192.168.1.2access-list 50 permit 10.107.196.33 Conditions and Actions are set as...

Hello, I want to configure routers (ISR4321 & 4221) to send an e-mail whenever there is a specific match in syslog. When I try EEM it seems that the client (router) is not authenticated by our e-mail server. I have found many tcl scripts on the inter...

Hello all, Recently I have configured a standard ACL (out) and applied it to a VLAN in order to keep users from accessing this particular VLAN. The ACL works great with one accept ion, I also have a server sitting inside of the VLAN that I created th...

My end customer wanted to enable lifecycle feature in Cisco prime device, but I am not familiar with  this Prime device.   Pls let me know how to enable lifecycle feature and what is the main purpose of this feature. And they also wanted to get alert...

Hi, I do need to deploy two lines of config to a few hundred network devices. The devices do exist in Prime, but I only want to deploy the config to a portion of the devices. I have have a list (csv) with the IP-addresses of the devices, is it possib...

Hi Team,   We have Cisco PI 3.2 in which we have few concerns as listed below, expert opinion on below would be appreciated.   1. We can see entire topology map in cisco PI 3.2 however when any optical uplink goes down will receive an alarm and along...

Hello Everyone,   Kindly i want to know if Cisco C881G Router module support dot1x Feature or not?   If it is support i want to know how to deploy it ?    

I'm looking into the use of Ansible and Napalm to do configuration management with IOS-XE, IOS-XR & NX-OS devices. One of the features of Napalm is to be able to manage the configuration as a whole and either do configuration merge or replace. I'm wo...

Hope you all are good. I got the feed from NTP server on my 6500 switch. After that I want that other devices on my network will get feed from my switch after authentication. But other devices on network is getting feed without authentication.   6500...

Is there a report that can be run based on the Active Alarms/Events in Prime Infrastructure 3.2?   I would like to automate and email a report on all of the "Authentication Failed" events to my security team so they could investigate these events.

Hello   I have the following problem:   Have a lot of Cisco devices on the network, each one has IP addresses on the Vlan interfaces (for example 1.1.1.1) and on physical interfaces from ISP (2.2.2.2) I run Job Discovery with range 1.1.1.1 The proble...

I am looking for some particular info on snmp views. If I have a single command such as "snmp-server view NMS 1.2.3.4.5 excluded" does this exclude only that value or do I need to add some sort of default allow?   If i have a single line snmp-server ...